0
The vehicle will surge at idle because of the vacuum leak. If the PCV valve has come apart it will take you 2 seconds to inspect. Just remove it, turn it upside down and look at it. If the spring loaded valve is gone, it has come apart. Try lowing through it one direction, then the other. It should flow fairly easily one way, but should feel somewhat restricted the other way.
What else can I help you with?
Where is the transmission control solenoid in your 2000 ford windstar?
where is the tcm in a windstar 2000 located
How do you figure out if your 2000 ford windstar is a 3.0 or 3.8?
I was looking at the 2000 Ford Windstar Owner Guide : The drawings of the engine compartment show : ( when standing in front of the vehicle ) The 3.0 liter V6 engine has the oil filler cap on the RIGHT side of the valve cover The 3.8 has the oil filler cap on the left side of the valve cover ( near the alternator )
Where is the expansion valve on a 2000 ford windstar?
The expansion valve on a 2000 Ford Windstar is located within the vehicle's air conditioning system, typically situated near the evaporator core, which is located behind the dashboard. To access it, you will often need to remove the dashboard or the HVAC housing. It's recommended to consult a repair manual for detailed instructions and diagrams specific to your vehicle.
Where is the coolant bleeder valve on a 2000 ford windstar?
The coolant bleeder valve on a 2000 Ford Windstar is located on the engine, near the thermostat housing. It is typically a small, plastic or metal screw that can be found on the upper part of the engine, often on the intake manifold. To bleed the cooling system, you would loosen this valve to allow trapped air to escape while the engine is running. Always ensure the engine is cool before attempting to locate or operate the bleeder valve to avoid burns or injury.
Where is the egr valve located on a 2000 ford windstar?
The EGR valve on a 2000 Ford Windstar is located on the intake manifold near the firewall. It is typically located to the left of the main throttle body or slightly lower than the throttle body. On the passenger side it is located on the side of the intake manifold closest to the firewall. On the driver side it is located on the side of the intake manifold closest to the engine.
Where is the air flow relay in 2000 Ford truck windstar?
where is air flow relay on 2000 ford windstar
Where is the heater control valve on a 2000 ford windstar?
The heater control valve on a 2000 Ford Windstar is located near the firewall on the passenger side of the engine compartment. It is typically situated along the heater hoses that run from the engine to the heater core. To access it, you may need to remove some components or hoses that obstruct your view. Be sure to handle any coolant carefully when working in this area.
Where is the pressure relief valve located on a 2000 ford windstar 3.8?
On a 2000 Ford Windstar with a 3.8-liter engine, the pressure relief valve is located on the fuel rail. It is typically situated near the fuel injectors and can be identified as a small metal cap or valve. To access it, you may need to remove any engine covers or components obstructing the area. Always ensure to relieve fuel system pressure before attempting any work on the fuel system.
What kind of oil do you need for a 2000 ford windstar?
According to the 2000 Ford Windstar Owner Guide ( 5W-30 )
Location of idle air control - IAC valve on 2003 Windstar?
It's located on top of the air intake, above the engine, looks like a sensor with a cylinder at the end, its attached to the acceleration body with 2 10 mm screws. See "Related Links" for a pictorial guide to removing & cleaning the IAC valve on a 2000 Windstar
How do you turn off passenger airbag on a 2000 ford windstar mini van?
my 2000 windstar sel you can not turn of the air bags.
Where is the inertia switch in a 2000 ford windstar?
In the cargo area , on the passenger side , behind the service panel ( on a 2000 Ford Windstar )
