answersLogoWhite

0

Front or rear? discs or drum? rotors or drums turned(resurfaced)or not? Many times when you just replace pads without resurfacing rotors will tend to be noisy and sometimes overheat causing warpage,pedal will pulsate upon application.Good luck

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Why do new brakes grind?

New brakes do not grind. If you replaced the brake pads and resurfaced the rotors you may hear a bit of a sound but it is normal until the pads and rotors wear during normal driving.


Do you need to grind the rotors when placing new brake pads?

If the rotors are in good condition, not warped, not scratched, then you can replace the pads without turning the rotors. Inspect the rotors carefully.


How do you change brake pads in BMW 750 2006?

remove old brake pads, replace with new brake pads voila!


Is it bad for your car if new brake pads squeak?

Generally new pads will contain a layer of dust which causes the initial squealing. The squeal should go away after a bit if driving.


How do you fix grinding noise on driver side brake pads?

buy new brake pads


How do you change brake pads on a 2007 Honda CR-V?

You can change the brake pads on your 2007 Honda by removing the wheel. Remove the brake pad springs. The brake pads will come off. Reverse the process to install the new brake pads.


How do you install brake pads on 1982 cutlass?

Replacing the brake pads on your 1982 Oldsmobile Cutlass is quite easy. Remove the brake pad Springs and caliper. The brake pads will come off. Reverse the process to install the new brake pads


What causes the engine to squeal when applying the brakes?

probably not your engine, sounds like its time for new brake pads. if this doesnt correct it have the master brake cylinder checked


Can you buy used but usable brake pads?

While it may be possible to purchase used brake pads, you should not buy used but usuable brake pads. You should only buy new brake pads in excellent condition.


Why are my new brake pads getting hot?

Brake pads normally yet hot under normal use. The brake pads will get excessively hot if they are not adjusted properly. The wrong brake pads can be too thick and might be rubbing on the rotor.


How do you change the rear brake pads on a 1993 escort gt?

The rear brake pads on your 1993 Ford Escort can be changed by removing the brake pad Springs and break caliper. The brake pads will come off. Reverse the process to install the new brake pads.


How do you change brake pads on CITROEN C3?

In order to change the brake pads, you must first remove the wheel. Remove the retaining clips and the brake pads will come off. Reverse the process to install the new pads.

Trending Questions
What is the cause of radiator smell inside car? Where to buy benzyl powder for carpet? Where is the fuel filter located on 1968 Pontiac firebird? How buck converter and boost converter cascaded? What does a STP S5 oil filter fit? Will a STP S5 oil filter fit a 250 Chevy? Im in the middle of the floor with your shirt off they better pray that the lights dont go out cause if they do then a hater get knocked out? Would 5w30 synthetic oil be recommended for a 2006 Yamaha ttr 230? What is the fuse rating for 3kw immersion heater? What size wrench to remove caliper bolt on 2005 Ford Freestar? What does a warning light with engine protection mean in a freightliner classic XL truck? Why would white smoke come out of my tailpipe after changing the valve cover gasket on my 95 Nissan 200sx it only does it on highways and has also started missing never had these problems b4? Does timing belt breakage do damage Nissan Pulsar 1989? Where can one purchase an a23 battery? Can after replacing heater core in 1989 Chevy S-10 blazer you hear a vacuum leak coming from behind the temp control switch the air only blows out the defrost and heater vents How do you fix this? Why did you need to have a licence to use a cigarette lighter in Portugal in 1947? My Daewoo Cielo 1998 model Automatic has a vibration when braking at a stop street the power light flashes what is wrong? How do you keep my catalytic converter from dragging the ground? Why does your car smoke white when i start it and then stop blowing? How do you reset the check engine light on 2000 Honda odyssey?