0
What else can I help you with?
Do brake rotors need to be replaced if there is no noise shimmy or other brake issues?
When Brake Rotors Are To Thin To Turn On A Brake Lathe To Have The Minumn Thickness. They Need To Be Replaced.
Do you need to drain brake fluid when changing brake pads and rotors?
no
Is it possible to replace one's own brake rotors?
If you are wondering whether it is possible to replace one's own brake rotors or not because you drive an older vehicle that need brake rotors replaced, then the answer is no.
When you brake your Chevy Trailblazer pulsates why?
The brake rotors are warped are out of round. Need to do a brake job and have the rotors turned are replaced. Be sure to install new pads and shoes.
Do you need a torque wrench when replacing pads and rotors?
You do not need a torque wrench when replacing brake pads and rotors. Some of the tools needed to change the rotors and pads are the c-clamp, sockets, wrench, grease, and brake cleaner.
Why is your car feels like its jumping when its stop?
When applying the brakes; if you feel the car jumping it's usually the brake rotors need "turned". And, all depending on the age of the rotors and how much your OLD brake pads have scraped them, you might need to buy new rotors. So, my answer is TURN or REPLACE brake rotors. <end>
Why does your car shimmies when you apply the brakes?
Your rotors are warped. You will need to have the rotors turned or replaced and new brake pads installed. Warped rotors are caused by over tightening the lug nuts or by excess heat from high speed stops or riding the brake pedal.
How many miles before you should change your rotors?
As long as your rotors are not warped, or you have not let the brake pads wear to the point they defaced the rotors, there is no need to change them. Just install new brake pads. Rotors can last the life of the car.
How do you change rotors on a 1991 accord?
remove tire calipers brake assembly then pull your rotors off i would recomend putting new brake pads if your putting new rotors you will need a special puller for the rotors cause they are pressed on
Do brake rotors need to be replaced in pairs?
No just the bad one.
How do you change the front rotors on a crx?
You will need to remove the tire and wheel. You can remove the brake pad and break assembly, by removing the brake spring and caliper. Loosen the rotors with a hammer. The rotors will slide off. Reverse the process to install the new rotors.
Brake pulsation New hubs and Rotors?
I don't know if you are saying you have the new hubs and rotors and still have pulsation, or if you are asking what causes pulsation. If you have pulsation on slowing this is due to warped rotors, and you need to change the rotors and the brake pads, not the hubs. Not too expensive: 2 rotors and brake pads for my Pontiac is about 55 bucks. DIY of course.
