Coolant bubbling in the expansion tank typically indicates the presence of air or gas in the cooling system, often caused by a blown head gasket, a cracked engine block, or a damaged cylinder head. This can allow combustion gases to enter the cooling system, leading to pressure fluctuations and bubbling. Additionally, overheating or low coolant levels can exacerbate this issue. It's essential to diagnose and address the underlying problem to prevent engine damage.
thermostat is stuck shut
As the engine coolant heats up, the coolant expands, so the coolant needs a reservoir or expansion tank to flow in and out of as needed.
thermostat or blown head gasket....
There's a sensor in the bottom of the coolant expansion tank.
In the expansion tank.
how do I replace my 2005 fiesta expansion header tank
To replace the expansion tank on a 1996 Volvo 850, start by ensuring the engine is cool and then relieve the coolant pressure by removing the cap. Disconnect the hoses attached to the tank, making sure to catch any spilling coolant. Remove the mounting bolts or clips securing the expansion tank, then lift it out. Install the new expansion tank by reversing these steps—secure it with bolts, reconnect the hoses, and refill the coolant to the appropriate level.
The rated coolant capacity of the whole system is 7 litres, but it might not be completely empty. The expansion tank is just the tip of the iceberg.
There shouldn't be just water in the expansion tank. If the coolant (50% anti-freeze and water) appears to be boiling in the expansion tank, you may have a bad head gasket or cracked head.
there is none. look for the coolant expansion tank there is where you add coolant to the system.
It is in the coolant expansion tank Problems with this sensor are common as they are pourous and take up coolant, eventually sinking and bringing on the coolant check light. You most likely will need to change the coolant expansion tank to cure the problem as it is usually sold as a unit. Kev
It sounds like the tank has a leak.