answersLogoWhite

0

What else can I help you with?

Related Questions

Why would a 2002 Pontiac Grand Am vibrate vigorously in drive when the brake is applied?

warped break disk


Why does my steering shake when brakes are applied?

Your brake rotors are warped and need replaced/resurfaced.


Why does the steering shake when brakes are applied?

Could be that the rotors are "out of round" and need either to be resurfaced or replaced


Where is the crankshaft sensor located on a 1997 Pontiac sunfire?

the 2.4 sunfire engine don't have crankshaft sensor, only have camshaft sensor. Yes they do have one.. well mine does.. it is above the oil filter kind of behind the rear of the starter.. pain in the but... Now I wanna know how to get it out?! ***************************************************************** I just replaced mine. It's right above the oil filter, can't see it from below. The way I did it was taking the starter out of the way and, because it was kind of stuck, I had to take the oil filter out also, it has an 8mm hex head screw, after taking this out, used a channel lock pliers to pry it out , it might be easier for you, maybe. Just be careful with the new one and not brake the o ring, I applied a dab of oil to get it lubed. Good luck! Alex from Mante, Mexico


What would cause a1994 Pontiac grand am to die when the brakeis applied?

bad eletrical system ground wire some where!


1994 cambry shakes when brakes are applied What is wrong?

Rotors out of round - need to be re-surfaced or replaced


Excel questionWhen you apply a style to text any conflicting formatting in the cell is replaced by the style format?

Any conflicting formatting will be replaced by the style that is being applied. Whatever formatting that may have already been applied to the cell that is different to the style will be set to be the same as the style.


Why does your 1986 Pontiac Firebird stop running when brakes are applied hard?

there may be a problem with the torque converter or there is a short in a wire some where


Why would the left turn signal stop flashing when the brakes are applied on a 2002 Pontiac Montana?

Your Pontiac has a problem in the electronic block, which is controlling the turn signals, the tail and brake lights and etc. It shouldn't be a big deal.


A noise is made when brakes are applied?

More than likely your brake pads are worn down to the backing plate and need to be replaced.


Why do my brakes still squeak on 2002 kia optima after replaced and anti squeal goop applied?

grease needs to be applied behind the rattle clip before rattle clip is put back on..need more info contact glennschevygirl@yahoo.com


What are tin dogs in antarctica?

I recollect hearing, perhaps in the 1960s, the name 'tin dogs' applied to the snowmobiles and other machines that eventually replaced real dogs in Antarctica.