0
What else can I help you with?
What is bolt torque for lower intake manifold for 97 buick lesabre?
The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.
How do you replace the water heater inlet pipe on the intake manifold on a 3800 buick lesabre?
replace the water heater inlet pipe on the intake manifold on a 3800
What are the torque specs for a 1993 Buick lesabre intake manifold?
You did not mention if it was the intake to the cylinder head bolts (1993 buick lesabre 96 in-lbs)..... or ..... the intake upper to lower bolts ( 1993 buick 132 in -lbs) but i hope you will know wich you are looking at since there is a large difference in torqe.
Where is the IAT sensor on 93 buick lesabre?
The IAT sensor is located on the intake manifold air cleaning housing or air duct.
98 buick lesabre keeps losing antifreeze an blows white smoke from tailpipe?
Most likely a cracked intake manifold.
What is the torque spec for 2004 3.8 Buick lesabre lower intake manifold?
The torque specification for the lower intake manifold on a 2004 Buick LeSabre with a 3.8L engine is typically around 11 lb-ft (15 Nm). It's important to follow a specific tightening sequence in multiple steps to ensure even pressure across the manifold. Always refer to a repair manual for the precise procedure and torque sequence for your specific vehicle.
How do you change a erg valve in 92 Buick LeSabre?
Most EGR valves are located on the intake manifold with a vacuum line attached. Most are held on with two bolts.
Where is the MAP sensor located on a 2005 Buick Lesabre?
The MAP (Manifold Absolute Pressure) sensor on a 2005 Buick LeSabre is typically located on the intake manifold. It is usually mounted near the throttle body, often on the driver's side of the engine. To access it, you may need to remove some engine covers or components around the intake area. Always consult a repair manual for specific details related to your vehicle.
WHAT IS code p0108 on a 97 buick lesabre?
Manifold Absolute Pressure/Barometric Pressure Sensor
Where is mass air flow sensor for 1997 Buick LeSabre located?
The 1997 Buick LeSabre mass airflow sensor is located on the outside of the air intake housing. The sensor can be found on the right hand side of the air intake housing.
What is Buick lesabre trouble code 23?
Manifold ait temperature sensor circuit. Year and model?
Where is the EGR valve in a 1997 Buick Lesabre V6 225 and how do you replace it?
Its at the rear of the engine in the intake manifold. Take the 2 bolts off that hold it and clean all of the carbon before installing the new one.
