answersLogoWhite

0

Any large vapor leak form the fuel system can turn the "gas cap" light on. You need to inspect for a cracked, broke, missing vapor hose from the tank to the engine.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why is the fire alarm still beeping after the battery has been replaced?

The fire alarm may still be beeping after the battery has been replaced due to a few reasons, such as a faulty connection, dust or debris in the alarm, or a need for a reset. It is recommended to check the connections, clean the alarm, and follow the manufacturer's instructions for resetting the alarm. If the issue persists, it may be necessary to contact a professional for further assistance.


What do you do when you have been woken up by an alarm?

Check your house and see if the door or window is open, or something is flaming.


Can someone help with a 1995 Jetta III GL The oil light blinks and a quiet alarm goes off the oil has been check and is fine.?

The oil alarm/light is related to a low oil pressure, so I think it is related to a bad oil pump, and not to a low oil quantity/level in your engine. (It happend me once, and the pump components had to be replaced).


Is it just coincidence that my alarm clock goes off everyday at the same time?

No. It has been set to do that. Check your instructions on how to change that.


What does the pedal relay mean when you check engine light comes on?

It means that your relay is out, and has to be replaced with a new one, and once its been replaced, your check engine light will turn off in about 20 minutes or so.


What is wrong with 1996 Corvette that runs rich and misses when idling but O2 sensors have been replaced and check engine light is off and there are no more codes to check?

CHECK THE TIMING


How do you reset your car alarm gryphon gy-gs750ra?

To reset the Gryphon Gy-GS750RA car alarm, start by inserting your key into the ignition and turning it to the "On" position without starting the engine. Then, press and hold the "Valet" button on the alarm's control module for a few seconds until the alarm chirps, indicating it has been reset. If the alarm continues to trigger, check the sensors or consult the user manual for additional troubleshooting steps.


In India FERA has been replaced by?

= FERA has been replaced by FEMA =


How do you locate alarm 2004 Chevy Venture?

the remote has been lost and a new remote has been purchased. i had to remove the fuse to get the alarm to stop. how can i reset the alarm? So i can program the new remote.


Why would a 1999 Chevy Tahoe continue to put out crank sensor and map sensor codes after both have been replaced?

You need to clear the codes with a engine scanner.


If you have been to prison does this show on CRB check?

Convictions that resulted in custodial sentences will always show up on a DBS check (DBS checks replaced CRB checks in 2012).


How many amendments have been replaced?

One amendment has been replaced