0
For a 1992 Ford F-150, the exhaust manifold bolts should typically be torqued to about 25-30 lb-ft (foot-pounds). It's important to follow the manufacturer's specifications and sequence when tightening the bolts to ensure a proper seal. Always refer to a repair manual for the specific engine type, as torque specifications can vary.
What else can I help you with?
Where is the water temp sending unit on a 1992 ford f150 4.9 located?
On the passenger side, way back, under the exhaust manifold.
Where is the Oxygen sensor 1986 f150 ford 5.0 located?
Just downstream after the exhaust manifold
How hard is it to replace exhaust manifold pass side on a 2008 ford F150 5.4L?
It is very hard.
Where is the oxygen sensor on a 1995 F150 inline 6 with a manual transmission?
Most oxygen sensors are in the exhaust pipe....between the exhaust manifold and the catalytic converter.
Would a 1991 f150 dual exhaust fit on a 1992 f150 both are 302 or 5.0L?
yes they are basicly the same truck
What makes the exhaust manifold get red hot on a 1991 Lincoln Continental?
it could be that your catylitic converter is plugged up. disconect the exhaust system and see if it glows red. if it does connect it back. this could mean that your muffler is the problem. if not this then it could be that an exhaust valve is cracked. the same thing happend to my 1992 ford f150. it could be that your catylitic converter is plugged up. disconect the exhaust system and see if it glows red. if it does connect it back. this could mean that your muffler is the problem. if not this then it could be that an exhaust valve is cracked. the same thing happend to my 1992 ford f150.
Smoke coming out from front of intake manifold on 1990 F150 truck?
If you aren't hearing a lot of exhaust noise and you're just getting smoke, you have either an oil leak or antifreeze leak that is getting on the exhaust manifold. If you're getting oil on the manifold you have a fire hazard and should take care of the problem immediately. If you hear exhaust gas leaking around the manifold you need to replace the gasket or possibly the manifold is cracked and you need to replace the manifold.
Would a 1991 f150 dual exhaust fit on a 1992 f150 both are 302s?
It should i don't think they changed the width of anything tell 97
Where is the O2 sensor located on a 1999 Ford F150 4x4 truck?
UNDER HOOD, DRIVER SIDE, LOWER ENGINE AREA, BELOW EXHAUST MANIFOLD FLANGE, MOUNTED IN EXHAUST PIPE
1986 ford f150 truck 6 backfiring through exhaust?
Intake manifold gasket may be leaking - check for loose bolts or replace fasket.
Where is the O2 sensor located on 1995 ford F150 V8 5.0?
on the passenger side underneath the cab. in front of the cat. where the exhaust manifold comes together.
Does a 84 f150 fwd 5.0 need a exhaust manifold gasket when replaacing manifold?
yes, most cars are not fitted with gaskets when manufactured. as you remove the exhaust manifold bolts the metal on both ends tend to warp and are not true to each other, therefore requiring a gasket to seal any potential leaks from the metal being distorted
