0
What else can I help you with?
97 safari no rear heat but fan works?
The heat relay needs to be activated by a vaccum switch. On my van the fix was to replace the vaccum line to the relay which allowed the relay to allow heat to travel to the blower.
Where is pre heat relay in Peugeot 307 1.4hdi 2004?
There is no pre heat relay on my Peugeot! You better check with Peugeot.
How does a contact relay weld?
Too much current cause excessive heat and cuases melting of the relay contacts.
Purpose of the indoor fan relay?
indoor fan relay An electric relay that starts and stops an indoor fan on cooling, electric - heating, and heat pump systems
Where is the compressor relay ON A 1997 MARK VIII?
For air ride compressor Its a 5 or 6 wire electronic relay with a heat sink mounted on the compressor bracket.
What are the limitations of a solid state relay?
Stay with-in the amperage capability, the voltage capability, and use a heat sink to dissipate the heat build up.
Where is the horn relay located on a 1982 corvette?
You can find the relay on the drivers side under the dash near the fuse box. The easiest way to get to it is to remove the heat/ac duct. It just has a couple screws. The relay will just pull out.
If the fuel pump is not working when you turn the key on will the relay still click?
Yes the relay will still click you could have blown a fuse that is for the pump, the relay on some models of engine is to only heat the fuel quickly for faster starting
Is it true or false that a heat anticipator should be set to match the amp draw of all heat relay controls in the control circuit?
True
Why does the heat not work in a 2004 Chrysler Pacifica?
replace heater relay and or heater blower motor
Why is your 98 Chevy Cavalier fan only works when the AC is on and sits still when off is there a heat sensor or a relay that might have gone bad?
The thermal relay may be bad.
Why would a 1986 Corvette over heat after changing the fan and heat switch but wont click on?
Yep. Had the same problem on my 86. Changed the fan,sensor and relay.If you jumper the outer terminals on the relay connection you can tell if the fan works. If it does fine but the signal to 'throw' the relay from the ecm isn't working.Check with a test light for this signal.If ok replace relay.
