It is a valve in the brake lines going to the rear of the vehicle. It adjust the amount of fluid flow to the rear brakes depending on the height of the rear suspension. The lower the suspension, the more weight in the vehicle, the more rear braking power is needed.
no,this valve intergrates with the sensors in the brake system. replace the HSP valve
Height sensing proportioning valve.
Lspv-load sensing proportioning valve is the part of break assembly .it senses the load of vehicle and aply an effective pressure with respective to the vehicle loaded or unloaded & break the vehicle.also avoid skiding of vehicle.
Not knowing what kind of vehicle you have, all I can do is guess that it is a load/height sensing proportioning valve.
The proportioning valve is used to determine the amount of brake power to be distributed to the rear wheels by sensing the height of the bed (differences in rear weight) if replacing valve you should properly bleed air out of system. The valve is there for a reason it should not be bypassed.
It is a height sensing proportioning valve. It controls rear brake pressure depending on load.
AnswerThe proportioning valve and warning switch is integrated into the master cylinder assembly.I think the proportioning valve is located on the frame rail under the master cylinder?Thats where it is on my 1980.The proportioning valve is not on the frame rail on an 84. It is inside the master cylinder.
No, the proportioning valve is used in the brake system to apply different forces of pressure to the front and rear brakes.
No, the proportioning valve is used in the brake system to apply different forces of pressure to the front and rear brakes.
No, not unless there is a problem with the valve which is rare.
Yes the kia sephia has 2 brake proportioning valve located on the fire wall
The proportioning valve adjusts the amount of fluid pressure between the front brakes and rear brakes, I would say the answer is yes.