0
A mono amp is an amplifier that puts out only one channel of sound, as opposed to a stereo amp that puts out two channels of sound. A mono amp is generally used for extremely low frequencies (ie bass) that are channeled into a single subwoofer. It doesn't matter that both stereo channels are combined for these low bass frequencies because you couldn't tell which channel the sounds are coming from anyway (because you feel the sound pressure more than hear the sound).
What else can I help you with?
How does a mono amp work?
A mono amp, is half of a stereo amp. It has one input and one output.
Can you power 2 door speakers on a mono amp?
A mono amp will not sound good with door speakers. There are to be used with subwoofers
How do you hook up a mono block amp?
the difference between a mono block and stereo amp is this: a stereo amp sees half of ohms you give it ( that is if you are trying to bridge it), the mono block see whatever ohm load you give it.
How does a amp work?
A mono amp, is half of a stereo amp. It has one input and one output.
Yes this amplifier is a mono amp so it is internally bridged. It does not have a stereo output. ?
Yes this amplifier is a mono amp so it is internally bridged. It does not have a stereo output.
What do you set your amp to for 2 12 subs?
to mono if your amp will allow, also this is for single voice coil. otherwise run in mono parallel to run dual voice coils.
For sub woofers do you need a mono amp or a 2 channel amp?
Depends if you are building heavy bass system with quite a few subs then a mono amp would be suggested but if it is just a single sub just for a standard bass upgrade then a 2 channel amp would be fine you can still use a mono amp on one sub just remember to take into perspective the RMS rating and the Impedance on both the Subs and the Amp
Stereo amp or mono amp for your sub?
Most preamps just have a mono output for a subwoofer. No real reason to run stereo for subs, unless maybe you are running two speaker boxes as subs. Most amps are switchable to mono mode and put out more power in mono. Hope this helps.
What is the best amp to run 2 jl audio 10w3v3 a mono amp or a 2 channel amp?
jl audio 500/1
What part is required to attach a mono ampto a factory stereo?
What part is required to connect a mono amp to a factory stereo
How do you bridge a four channel amp to a mono block?
u can bridge it to 2 channels not one to make it a mono block
How many phoshates does AMP have?
AMP is the abbreviation for Adenosine Monophosphate. The mono meaning 1. So it has 1 phophate group.
