35- idle air control (iac) valve/ circuit
That REQUIRES an ENGINE SCANNER to do that.
I have the check engine light on and the code is for map sensor on my 1999 1500 Chevy suburban
See link below.
A flashing check engine light usually indicates a misfire. You need to check codes to know possible causes.
To reset the check engine light on a 1996 Chevy 1500, you can disconnect the negative battery cable for about 15 minutes. This will clear the vehicle's computer memory and turn off the light. Alternatively, you can use an OBD-I scanner to clear the codes if you have access to one. Keep in mind that if the underlying issue causing the light to turn on is not resolved, the light will likely come back on.
Check the fuses, Check the bulbs, Check the brake light switch, In that order.
a 2000 dodge ram 1500 the check engine light is on and the code says torque converter and clutch and overdrive solenoid. what do you think that the problem is?
There is not one sensor. All the ECM sensors are tied to the check engine light.
Your ECM has deteced a problem with the emissions system. The light can be reset after the problem is repaired. You need an OBD2 scan tool to reset the light.
A Dodge Ram will have a check engine light appear when the engine needs to be serviced. You can reset this light by following the directions in your manual or by having your mechanic do it.
You hook up a scanner and check it for codes.
The engine computer has detected a malfunction and set a code.