0
What else can I help you with?
Wiring diagram for kenwood excelon kdc-x817?
The wiring diagram for the Kenwood Excelon can be found in its service manual. This service manual can be obtained from Kenwood upon inquiry.
How do I install a kenwood Car stereo in a ford ED falcon?
I will try to make this as simple as possible starting with the tools you will need. Phillips Head screw driver or cordless drill Pointy nose plyers and wire stripper Soldering iron and solder Something to test your wiring to see which one has power Heat shielding or electrical tape I think that's it! The red wire is normally power and the black ground, the speakers are something you can work out by sound or looking at the speakers they are connected to. The kenwood will come with a harness that plugs in the back of the steroe, the ford harness will not fit the kenwood so you will have to cut the ford harness (not to short from the plug) and then solder the kenwood harness on to it. Hope that helps.
What is the wiring diagram for Kenwood krc-309s?
You mean where can i find the wiring diagram.
Wiring diagram for a kenwood car DVD player?
Wiring diagram for instalation
Where can I get wiring diagrams for the Kenwood KSC-WD250 Subwoofer I am missing the factory wiring harnesses?
The wiring harness can be purchased from partsstore.com or a Kenwood Parts Distributor (1-800-421-5080) for $19.62. If you're missing the wired remote you're in more expensive trouble. It cost around $94.16 to replace and in my opinion is way too expensive to replace when a complete subwoofer with accessories can be ordered for less off of ebay. Good Luck!
How do you identify the wires on a kenwood kdc-mp528 car stereo?
kenwood car stereo kdc-mp528 wiring diagrahm
What is yellow in kenwood wiring?
In Kenwood wiring, the yellow wire typically represents the battery or constant power supply. This wire is used to maintain memory functions for the stereo, such as saved radio stations and settings, even when the vehicle is turned off. Always refer to the specific wiring diagram for your Kenwood model for accurate connections, as configurations can vary.
Were do you hook up wire on kenwood stereo for parking sensor?
To hook up a parking sensor to a Kenwood stereo, you typically need to connect the sensor's output wire to the stereo's reverse trigger wire, which is often labeled as "reverse" or "backup" in the wiring harness. This wire usually activates the stereo when the vehicle is in reverse, allowing the parking sensor to function. Make sure to consult the specific wiring diagram for your Kenwood model and the parking sensor system for accurate connections. Always disconnect the battery before making any wiring modifications to avoid short circuits or damage.
Can a Kenwood KDC-248U fit in a 1999 for explorer?
Yes, a Kenwood KDC-248U can fit in a 1999 Ford Explorer, as it is a standard-sized single DIN car stereo. However, you may need an appropriate dash kit and wiring harness to ensure proper installation and compatibility with the vehicle's existing wiring. Always check for any specific installation requirements or modifications that might be necessary for your particular model.
Where is wiring harness on 2004 Buick regal?
There is a wiring harness most everywhere you look on that and any vehicle. Be more specific.
How do you replace a wiring harness on a Dodge Ram?
The wiring harness can be removed by unplugging all of the wires. The wiring harness is also held in place by several retaining screws. Remove the retaining screws.
Wiring harness Mazda truck?
The purpose of the wiring harness is to help keep wires together instead of hanging freely. You can purchase a new wiring harness at any auto repair shop.
