answersLogoWhite

0

Sometimes the self adjust rod gets rusty or corroded. When that happens it also damages the arm. Replace them both.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Brakes adjustment Daewoo nubira?

The brakes automatically adjust every time you back up and use the brakes to stop. The automatic adjustment is common in most automobiles.


What is the most common brakes on a tractor trailer?

The most common brakes on a tractor trailer are the s-cam brakes


Is it common for the rear disc brakes to wear faster than the fronts for a 2001 Sable Wagon?

No that is uncommon. Front pads normally wear more rapidly. Check the parking brake adjustment.


What are some common issues to look out for when maintaining old bike brakes?

When maintaining old bike brakes, common issues to look out for include worn brake pads, loose or sticky brake cables, misaligned brake calipers, and worn brake levers. Regular inspection and adjustment can help ensure proper brake function and safety while riding.


Two of the most common factors leading to brake failure are wet brakes that result from driving through puddles and?

in older cars with 4 wheel drum brakes riding the brakes down a hill will heat up the drums causing the brakes to fail. another cause is brake lines failure another cause is leaking wheel cylinders shall i go on? The most common part that fails in a braking system is the Master Cylinder.


What could be causing my brakes to feel spongy after bleeding them?

There are a few possible reasons why your brakes may feel spongy after bleeding them. One common reason is air bubbles remaining in the brake lines, which can happen if the bleeding process is not done properly. Another reason could be a leak in the brake system, causing a loss of brake fluid. It is important to check for these issues and address them promptly to ensure your brakes are functioning properly.


Why won't my bike brakes release properly?

There could be several reasons why your bike brakes won't release properly. Some common causes include: Brake cables may be frayed or kinked, preventing them from moving smoothly. Brake pads may be worn out or misaligned, causing them to stick to the wheel rim. Brake levers may be loose or need adjustment. Dirt or debris may be clogging the brake mechanism, hindering its movement. It is recommended to inspect and potentially replace any damaged components, clean the brake system, and adjust the brakes as needed to ensure proper release.


How do you determen what is causing the erratic fuel gauge 2002 Montana?

Fuel Sending Unit is bad. It is a common problem in these vans!


Why do the brakes not release when foot off pedal?

When brakes will not release when a foot is off the pedal, this is called sticking. There are various reasons for brakes sticking, but the most common involve an obstruction with the brake cable or the brake pads physically sticking to the drums or rotors. The safest way to remedy this problem is to have a professional inspect the vehicle.


83 olds toronado have to pump 3 times at least before it will stop?

I have a 1982 olds toro. I have the same problem as you. I talked to a cadillac dealer on this problem. He said that is was a common problem because of the 4 wheel disc brakes. But he said he does not know how to fix it.


What does drum brakes and disc brakes have in common?

They employ friction to slow or stop the vehicle.


Is there any problem with uneven breasts?

Having uneven breasts is a common problem, however there are no health risk with it unless there is a lump causing the unevenness. If that is the case then one should have them checked by a doctor.