I have owner's manual for MB 126 300 SE, SEL, and they write fluid for Power Steering is named MB Power steering fluid, capacity: 1.3 l (1.4 US qt), for rear axle Hypoid gear oil SAE 90, 85 W 90, capacity: 1.1 l (1.2 US qt) but they also write that "Your authorized MERCEDES BENZ dealer will advise you on recommended brands." That's all.
Added: DexIII/Merc is an acceptable power steering substitute. Per MB service bulletin.
What is the correct power steering fluid for a 2006 Mercedes E350 4matic?
check the dealer
That is the correct spelling of "servicing" (doing maintenance or repair).
u can use dexconn III trans fluid too
Contact a Mercedes dealer. Febi/bilstein Part# 08972 comes in 1 liter bottles. The power steering capacity is 0.6 liters(0.6US qt)for a 1990 190E 2.6
To check the rear differential fluid level on a Mercedes-Benz 190E, first, ensure the vehicle is on level ground. Locate the fill plug on the differential housing, typically found on the side. Remove the fill plug using a wrench; the fluid level should be just below the plug opening. If fluid seeps out when you remove the plug, the level is adequate; if not, you may need to add the appropriate differential fluid until it reaches the correct level.
In a Mercedes CLK 500, you can find the power steering fluid reservoir near the front of the engine bay, typically on the driver's side. The vehicle requires a specific type of power steering fluid, usually referred to as "MB 001 989 24 03" or similar, which is different from standard power steering fluid. Always check your owner's manual for the correct fluid specification and ensure you use the recommended type to maintain optimal performance and avoid potential damage.
What are correct torque settings for 1995 mercedes e420 wheel nuts?
No. Servicing is singular, and takes the singular verb "falls;" and "following items" needs the definite article.
The condition for correct steering is that the vehicle's wheels have to rotate at the same instantaneous center (found on the axis of rear wheels).
its push and pull way
A differential backup backs up all changes since the last full backup. To restore everything only the last full backup and the last differential backup are needed.