0
Pre terminated wires may mean one of a couple things. At least to my knowledge.
Generally a pre terminated wire is a wire in use or that is connected thru in an operating device of some sort. The wiring in the state it came from the "assembly plant.'
Non-terminated wiring generally refers to wiring that is not in use or not connected yet.
"Terminated wires" are "connected wires."
Pre-terminated could also refer to some wiring that already has the "connectors" placed on the wire. Not just a bare wire w/o connectors.
Non-terminated could mean a piece of wire without "connectors" on it.
What else can I help you with?
What is the difference between 12 2 and 14 2 wiring?
2.4
What is difference between cleat and conduit wiring?
Cleat wiring is exposed while in conduit wiring the wires are well protected inside tubes/pipes.
Is there a difference in a 96 and a 97 cavalier 2.2L engine such as in the wiring Is there two difference wiring diagrams of the 2.2L engine and where can I get a complete photo of a 96 and 97 2.2 eg?
There is a difference in the wiring and ECU between 96 and 97. I don't have a wiring diagram for them, but I believe most haynes manuals should have it. The 97 harness and ECU is a much more desirable setup if you intend to tune the engine since the 96 ECU is not supported by any aftermarket tuning programs.
What is the difference between a black wire and a white wire in electrical wiring?
The difference between a black wire and a white wire in electrical wiring is that the black wire is typically used as the hot wire to carry electrical current, while the white wire is usually used as the neutral wire to complete the circuit and return the current to the power source.
Whats the difference in wiring between a 1974 and 1975 cj5?
none that i know of because the wiring diagram i have says its for a 74-75 cj5. but i have noticed a few wires on the chart are different than my stock wires on my jeep. so the only difference i would say might be some of the colors
Stair case wiring diagram?
potential difference
What is the difference between line and load in electrical wiring?
In electrical wiring, the line refers to the incoming power supply, while the load refers to the device or component that uses the power. The line carries the electricity to the load, where it is used to power the device.
What is basic difference between an elementary wiring diagram and a connection wiring diagram?
An elementary is a schematic or one line diagram showing the basic operation of a circuit and is best used for troubleshooting or discussing circuit operation. A wiring diagram shows point to point wiring connections, terminal points, component layout etc. and is used to connect and build a circuit.
Is there a difference between a 1996 dodge neon wiring harness and a 1998 dodge neon 2.0?
yes.different plugs on several sensors and the plugs going into the pdc and ecu.
What is difference between a desktop computer and a laptop computer?
desktop goes on your desk cause its big it can also hold storages but needs lots of wiring but a laptop it the oppistie
What is the difference between 1sec and 3sec duration of short-circuit withstand capacity?
The difference between 1 second and 3 seconds is 2 seconds. In terms of short-circuit withstand capacity, it can mean the difference between no damage and damage occurring to the equipment and wiring. Heat rises extremely fast in a short-circuit situation, and you want your protective device to trip before damage is done.
What are the difference between a e350 1992 trans and a 1995?
The differences between a 1992 E350 and a 1995 E350 transmission are in its mounting, gear ratio, and wiring. Both function in similar ways however they are not directly compatible with each other.
