Its called a Quick-disconnect tool its like 10-15$ at a parts store
To remove the third brake light on a 1994 Ford Bronco, start by opening the rear hatch and locating the light assembly. Remove the two screws securing the light in place, then gently pull the assembly away from the vehicle. Disconnect the wiring harness by pressing the release tab and pulling it apart. Finally, you can replace or service the light as needed.
Remove transmission and replace the rear main seal
vacuum hose dimgram for 1994 ford bronco
Measure each brake line and go to the parts house and get the necessary lines. You will need a tubing bender. Remove the old lines one at a time and bend as needed. install the lines and then fill the master cylinder and bleed each wheel.
g7qQLk bviuxdmkojar
with the door open, there r pins where the hings r, knock those up, disconnect any wires, and tada
It just snaps in. remove gently. You may need a special tool that auto body shops use.
The horn relay in a 1994 Ford Bronco is located on attached to the cruise module. The electrical relay is under the hood.
There's usually a sticker under the hood with one on it but if not, you'll have to buy a motor manual with one in it.
Put a pan under the transmission. Remove the plug with a suitable box or socket wrench and let it flow.
On a 1994 Ford Bronco, the starter is located on the driver's side of the engine, near the transmission bell housing. It can be accessed from underneath the vehicle, typically requiring you to remove the protective splash shield if present. The starter is mounted to the engine block and connected to the battery and ignition system.
www.jeffsbroncograveyard.com