answersLogoWhite

0

look for a reset button, either on a tire well or on the steering column on the top May require insertion of spare fuse into special slot in fuseholder to read code. Clear code by temporarily cutting power (easily done by removing negative battery cable. Answer--- If you or a friend has a hand held OBD-II scanner, just connect it to your data link and use it to clear the codes.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How much does the engine way for a 1996 Geo Metro?

The engine of a 1996 Geo Metro weighs approximately 150 to 200 pounds, depending on the specific engine type and configuration. The Metro typically came with a 1.0L or 1.3L four-cylinder engine. This weight is relatively light compared to many other engines, reflecting the Metro's design as an economical and fuel-efficient vehicle.


Wiring for 1996 Geo Metro diagram?

The wiring diagram on a 1996 Geo Metro is located inside the service manual. It details the location of each electronic component and how they are connected to each other.


How do you reset the Service Engine Soon Light on a 1996 Infiniti I30?

How Do I reset the Engine service light on a 1996 Inifiniti I30? Please help. thanks


Can you replace a 1996 Geo Metro engine with a 2000 Geo Metro engine?

yes and the transmission too is recomended..... These trans are not so reliable and if there's lower miles on the 2000 you should swap out the entire rig


Where can you get a diagram of a 1996 Geo Metro engine to see were your belts go?

you can get a diagram in the service manual. Answer---- You can usually go to your local Autozone and ask them for a print out on the belt routing for almost any vehicle. I know, because I used to work for them.


Will a transmission from a 1991 Geo Metro fit into a 1998 Geo Metro?

No, a 91 metro transmission will not fit in a 98. A 91 will fit any metro between 1988 - 1996 though. After 1996 a lot of Metro's became 4 Cylinder which made them different from the previous generation metros. It may fit if the engine sizes are correct (1.0 litre 3 cylinder to the same but do not mix and match).


When did Energy Breaker happen?

Energy Breaker happened in 1996.


Is the crankshaft nut on a 1996 Geo Metro right-hand or left-hand threaded?

Right hand. But, it is torqued to about 200ft lbs. It will take more than a breaker bar to remove it.


When was Metro Sports created?

Metro Sports was created in 1996.


When was Metro Voices created?

Metro Voices was created in 1996.


When was Metro Plaza created?

Metro Plaza was created in 1996.


When was Taipei Metro created?

Taipei Metro was created in 1996.