0
What else can I help you with?
What size bolt connects the brake line to the brake caliper on a 1987 suzuki samurai?
The size is probably an half inch bolt to 3/4 bolt.
Can you use Teflon tape on brake line fittings and can you use standard tappered pipe fittings for hydrolic brakes with Teflon tape?
You do not need tape on any flared fitting, brake or regular. The brake line and the fittings are different size and thread type than regular copper line and fittings. You can't mix them.
What size brake fittings 1997 Jeep Wrangler?
1/4 inch line, 3/8ths fittings.
What is Suzuki GS brake line bolt size?
10mm.. not 12mm
Where are fittings on 94 Corsica?
On a 1994 Chevy Corsica, fittings for various systems can be found in several locations. The fuel line fittings are typically located along the fuel rail near the engine, while the brake line fittings are found near the master cylinder and along the brake lines. Additionally, if you're referring to AC fittings, they are usually located on the AC compressor and the accumulator. For specific components, it's best to consult a repair manual or diagrams for detailed locations.
How do you change a brake line on the brake booster?
The brake lines are not attached to the booster. They are attached to the master cylinder. To remove them, use an opened end wrench on the fittings located where the lines meet the master cylinder and slowly turn counter clockwise. BE CAREFUL NOT TO STRIP THE FITTINGS THEY ARE MADE OF BRASS AND ARE VERY SOFT!
How do you fix a leak in the brake line at the rear drum of a 1999 Honda crv?
There is no safe way to repair a broken or leaking brake line. The line or tubing that is leaking must be replaced or a new piece of tube, spliced into the line with fittings, to replace the leaking area.
How do you replace rear brake line on a 1969 camaro?
just unscrew it at the fittings and take it off and take it to the parts store with you and get another line at the parts store and bend and reinstall.
How do you unclip a brake line to replace it on a 2004 chev impala?
To unclip a brake line on a 2004 Chevy Impala, first ensure the vehicle is safely elevated and secured. Locate the brake line clip, which may be held in place by a retaining clip or bracket. Use a pair of pliers or a flathead screwdriver to carefully release the clip, being cautious not to damage the line. Once the clip is removed, you can disconnect the brake line fittings using a brake line wrench to prevent rounding the nuts.
What size are the steel brake line on a 1996 t-bird Are they metric as everything else is or SAE also the fittings metric or standard?
The brake lines are 3/16", the fittings are metric a 131 mm wrench to get them off. These lines use a bubble flare, so pre-flared lines are the way to go. Also there are fittings available that switch from the metric bubble flare to the more familiar 45 double flare, if you just need to replace a section of the line.
How many fittings can you pick up on a one half inch copper line?
never heard of the fittings,now you can run 2 fixtures off that line,not fittings
Why do you hear air when you push your brake pedal?
Assuming you're in an air brake equipped vehicle, it could be a number of reasons. Loose air line fittings, ruptured air lines, or bad gaskets in one or more brake chambers would be the primary culprits.
