0
To remove the crankshaft position sensor on a 1999 Mercedes-Benz ML430, you typically need a Torx socket size T25. Make sure to use the appropriate socket to avoid stripping the fastener. Always consult the vehicle's service manual for the most accurate information and specifications.
What else can I help you with?
What size socket is used for the crank pulley of a 2.4 4-cylinder?
22mm socket. Good luck!
How do you replace a crankshaft sensor on a 1991 Buick Century?
Haynes repair manual available from www.amazon.com. Not hard. Locate sensor, unplug electrical connector, use socket of appropriate size, remove.
Where is the crank sensor on a Chevy Lumina Z34?
what year? and what size engine? crank sensors are in different locations based on year and engine size.
Where is the oil pressure sensor on an 2006 Chevy Express?
It is located in the rear of the engine. You must remove the engine cover inside the cabin. The sensor is in the middle, back of the engine. Assuming the engine is in front of you. It requires a deep socket size 1-1/16 to remove sensor.
What is the bolt size for crank position sensor 94 Jeep Grand Cherokee?
i had a '98 and it was 11mm. If i were you i would buy a swivel socket and an 18" extention. Makes it much easier, 15 min job.
Where is a crank sensor located on a 99 cavalier?
what size engine 2.2
What size is the bolt for 03 Tahoe crank position sensor?
The crank position sensor on a 2003 Chevrolet Tahoe typically uses a 10mm bolt. It's recommended to use a socket or wrench that fits securely to avoid stripping the bolt. Always check the vehicle's service manual for the most accurate specifications and torque settings.
What size Socket is used for the crank pulley of a 2.5 4-cylinder?
it would be a 19mm or a 22mm
What tool do you use to take out battery?
The correct size socket and ratchet to remove the hold down. And the correct size socket to remove the battery cable clamp.
Where is crank shaft sensor on 1996 chev?
Need to know what size engine it has.
What size oxygen sensor socket wrench for 1998 Honda Accord ex v6?
All oxygen sensors are the same size. They standardized them because it takes a weird socket with a slot in the side to remove an O2 sensor, and no one wants to own seven or eight different sockets that can turn, at most, four fasteners on the whole car.
What size Allen socket is needed to remove caliper bolt on a 2004 Escape?
What size Allen socket is needed to remove bolt from caliper on 2004 ford escape
