answersLogoWhite

0

To calculate the static pressure at a depth of 25 feet with a psi of 80, we need to consider that 1 psi corresponds to approximately 2.31 feet of water. Therefore, the pressure in feet of water at 80 psi is 80 psi × 2.31 feet/psi = 184.8 feet. At a depth of 25 feet, the static pressure would be the sum of the atmospheric pressure (typically 14.7 psi at sea level) and the pressure from the water column. In this case, the static pressure at 25 feet is approximately 80 psi, assuming the measurement is taken at that depth.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

What psi is considered a high pressure pneumatic system?

factory air pressure norm is 80 psi


Which is the oil pressure of camaro z2897 5.7 engine?

between 20 and 80 psi between 20 and 80 psi


What should be the minimum pressure in domestic water pipeline?

Optimal household water pressure should be between 40 psi - 80 psi. If water is supplied by public water usually they supply the minimum pressure. If you have more than 80 psi, a pressure reducer is recommended.


What should the oil pressure be in a 1986 Mercury Grand Marquis?

40-80 PSI cold.20-40 PSI hot.40-80 PSI cold.20-40 PSI hot.


What is normal Oil pressure on 1984 Oldsmobile silhoutte?

Over 20 psi at idleUnder 80 psi while driving Over 20 psi at idleUnder 80 psi while driving


What is normal water pressure supposed to be?

80 psi or less


What is the tire pressure for a 155 80 r13?

32 psi


What is the oil pressure gauge suppose to read on a 1999 covette 40 or 80 psi?

Around 80 psi cold at startup, and 40 psi at normal operating temperature.


What is maximum residential water pressure?

I just had a home inspected, and the inspector measured the static water pressure at 115 psi. He noted that this pressure shouldn't be above 80 psi and recommended installing a pressure reducing or regulating valve to get the pressure down to 80 psi. He warned that too much pressure stresses pipes, fittings, and valves and can cause any of these to fail. Most solenoid valves on a washing machine or dish washer would not like to see over 80 psi Gage. other valves like faucets and boiler drains my leek sooner but will not be effected as much. The pressure relief valve on your water heater may exceed its 150 psi if heating from a cold take with out a domestic expansion tank, especially with existence of a check valve at the water meter.


What should your home water pressure gauge read?

8 PSI min - 80 PSI max


How much water pressure should be in the house?

40-80 psi.


What is the correct oil pressure for a 1997 Tahoe?

60-80 psi cold, 30-45 psi hot.

Trending Questions
Why your tires were skidding getting towed? 1998 Chevy Venture overheating Low coolant light is on along wth check engine light First 2 or 3 minutes of running check engine light is blinking and the car runs very rough then the light just stays? If the weather is dry is it okay to leave your hubs locked in case you need to switch to 4 wheel drive? How do you Change wiper switch on 1995 Saturn SC? How do I know if a drive shaft is bad? Where will car leak antifreeze if its a bad water pump? How do you change the drive belt on a gt235? What type transmission fluid you need for a 93 Chevy caprice? How do you connect new 6x9 rear speakers to the factory wiring in a 1990 Mercury Topaz? Is 230V compatible with 250v plug socket? Why would a 1996 Chev truck brakes go most of the way to the floor after new master cylinder bleed the brakes. Worked on the brakes themselves but still brakes go almost to the floor.? How do you replace the fuel filter on a 1997 ford f250? How much are emg light new coil pack and spark plugs for a citroen xsara Picasso what is the cost of these parts? What kind of headlight lens can cut the amount of light it emits by 90 percent? Can bad eg valve cause high oil consumption? What is a bad timing belt on an Audi? Why do new brakes squeek? Would you gain anything by cutting the tailpipe off behind the muffler? 1998 Chevy S10 2BY2 2 5 engine you have blown a spark plug and it is stripped out What is the best way to repair? Can tire rotations extend tire tread?