0
The timing for a Chrysler LA 318 is 5 degrees before TDC. When installing a distributor ensure that you have the engine at 5 degrees before TDC and then rotate the distributor till the rotor is just before the #1 cylinder terminal and the points should just begin to open. After you have done this, tighten down the hold down clamp just tight enough so you can still rotate the distributor. Mark the 5 degree before top dead center on your pointer with a white paint pen, then mark your damper scribe mark with the white paint pen. Disconnect your vacuum line from your vacuum advance and plug the hose with a gold tee. Hook up your inductive timing light and then start the engine. Aim the light at your damper and rotate the distributor clockwise until your marks align. If the engine RPM increases loosen the throttle linkage on your carb until the engine is at about 750 rpms or a suitable range for you. After you have completed this take the vehicle out for a drive and make any carb adjustments and recheck your timing once you park the vehicle again.
What else can I help you with?
Can you eliminate the egr on a 1973 318 Chrysler motor?
can you eliminate the egr on a 1973 318 chrysler motor
What causes the timing to jump on a 1978 Dodge 318 motor?
Worn timing chain.
What is the Timing 1968 318 dodge truck motor?
18436572
How do you set the timing on a 1980 Chrysler Newport 318?
To set the timing on a 1980 Chrysler Newport with a 318 engine, first, ensure the engine is at operating temperature. Then, locate the timing mark on the crankshaft pulley and the timing tab on the engine block. Using a timing light, connect it to the battery and the number one spark plug wire, then aim it at the timing marks while the engine is running. Adjust the distributor until the timing mark aligns with the specified degree setting (usually around 5-10 degrees BTDC), ensuring the engine runs smoothly.
Did a 1961 Chrysler Newport come with 318 or 363 motor?
361is in my 61 Newport.
What is the setting for the timing on a 92 Dodge Dakota with a 318 V8 2wd?
your timing is not adjustable. the pcm controls the timing. your dis. is index.
What is the degree for timing on a 1999 dodge durango 318 Chrysler engine?
It is set to zero degrees with a scan tool. It can not be done with a timing light.
How do set the timing on a 1986 Chrysler Fifth Avenue v8 318 engine?
pull and plug vacuum line to spark computer, adjust timing
Should I disconnect vacuum when setting timing on 1983 Dodge 318?
yes, unhook the vaccum hose to the distribuetor to set the timing.
What is the timing setting for a 72 dodge charger?
Start the engine and point the timing light at the timing marks. The flashing timing light will cause the timing mark on the harmonic balancer appear to be stationary and aligned with the timing marker. It should be lined up with "10 BEFORE." If not, turn the distributor until it is. Turn off the engine and tighten down the distributor hold-down. Unhook the timing light. Read more: How to Set the Timing on a 1974 Dodge 318 Motor | eHow.com http://www.ehow.com/how_7405118_set-1974-dodge-318-motor.html#ixzz2S9e9ResE
How do you set the timing on an 1985 and 1989 Chrysler 318 that has no timing degree makers on the block but there is a line in the balancer?
I'd just set it by ear and how easy it starts once it's set.
Can anyone tell me the Ignition timing for 2001 Dodge ram 1500 magnum 318 motor?
It is synced to the crankshaft with a scan tool. It can not be done with a timing light.
