It is tubular piece that connects the chassis to the wheel. you can also visit autospatech.comfor any accessories.
what i know you can't take that ball joint to upper control arm but if you buy the upper control arm the ball joint comes with it.
The upper arm is under voluntary control. This means that you can consciously move and control your upper arm muscles when you want to, such as when you reach for something or lift an object.
They would be connected to two control arms, one upper control arm and one lower control arm.
To change the upper control arm on a 1994 Lincoln Mark VIII, start by safely lifting the vehicle and removing the front wheel. Next, disconnect the upper control arm from the steering knuckle by removing the bolts and separating it from the knuckle. Then, remove the bolts securing the upper control arm to the chassis and take out the old control arm. Install the new control arm by reversing the removal steps, ensuring all bolts are torqued to the manufacturer’s specifications.
To replace the upper control arm on a 2000 Kia Sportage, first, safely lift the vehicle and remove the wheel. Then, disconnect the ball joint at the upper control arm, followed by removing the bolts securing the control arm to the frame. Once the old control arm is removed, position the new control arm in place, secure it with bolts, and reconnect the ball joint. Finally, reattach the wheel and lower the vehicle.
Part Of Upper Control Arm
155 ft. lbs. for the upper control arm-to-frame bolts.
It's part of your front suspension
u change it
You will need to replace the upper control arm. My research has determined it is not possible to purchase the ball joint seperately. If you do happen to find the ball joint you will have to press the old one out of the control arm which can be a real pain. Autozone has a tool to do it with but I am opting to just change the control arm so the bushing are also new. Moog Part number for the Upper Ball Joint is K80008. This is WITHOUT the control arm. Changing the control may prove to be easier but will most likely be a dealer item.
You have to replace the whole control arm on front upper ball joints in that particular vehicle.
To replace the upper control arm bushing on a 1987 El Camino, first, lift the vehicle and secure it on jack stands. Remove the wheel, then unbolt the upper control arm from the chassis and the spindle. Use a bushing press or a suitable tool to extract the old bushing from the control arm and install the new one, ensuring it is properly seated. Reassemble the control arm, reattach the spindle and chassis, and double-check all fasteners before lowering the vehicle.