Basically turning strength. You can get more torque by a wrench than you can by a screwdriver. An engine with high torque is better at getting things moving and accelerating.
the current gen 09 TRD 5.7L v8 has 381 hp and 400ft-lb of tourque with the new supercharger from TRD it can get 504hp and 550ft-lb of tourque WOOT!!
138 inch pounds
160 foot pounds
i have been told it is 60lb
There is a Spec and using a Tourque wrench is recomended when ever possible and reasonable. But the real answer is No, Just don't break it.
P0743-Tourque converter circuit electrical
first you must remove the transmission from the van then you gentely remove the tourque conerter from the front of the transmission and the seal is located where the shaft the tourque was on enters the transmission remove the old one and reinsert the new one, oil or grease the tail shaft on the tourque so when you reinstall it you wont damage the new seal gentely reinsert the tourque converter turning it slightly make sure it slips back 2 notches if it's not overdrive, 3 notches if it is overdrive the rest is reverse of the removal process when your done check the fluid!
because the compressor isn't getting enough tourque
To counteract the the right hand tourque produced by the clockwise rotating engine
Either the engine or the transmission has to come out to remove the torque converter.
how ican find the transmition solenoid tourque for 1998 chev venture
stock the 5.7 vortec's had 255 hp and 330 ft pounds of tourque