answersLogoWhite

0

Sometimes U can use a 90? pair of needle nose pliers or U can pull off the 2 small bolts holding the plate on-then take thick grease & put on the shaft & install the pump FAST or there is a bolt INFRONT of the engine that goes through 2 that rod-take out the short bolt & install a longer bolt(3/8 corse thread) 2 slightly put pressure on the FALLING out rod.Sometimes U need 2 put a taper on the longer bolt(JUST ON THE END) 2 hold the rod in place.then REINSTALL the ORIGINAL bolt BEFORE U START THE ENGINE.

User Avatar

Wiki User

20y ago

What else can I help you with?

Related Questions

Is rtv sealant necessary when replacing intake manifold gasket in 1994 Chevy 5.7 350 engine?

You need the sealant on the ends where the supplied gaskets don't cover fully.


How do you fix AC Heater control unit on 1992 Chevy pickup?

They are fully electronic. If you're sure it's the controls, you'll have to buy a new one from the dealer or a used one from an auto wrecker.


Where is the convenience center located on a 1992 Chevy c1500 pickup?

On a 1992 Chevy C1500 pickup, the convenience center is typically located under the dashboard on the driver's side. It is often found near the fuse box, and it houses various electronic components and relays that control features such as the power door locks, windows, and interior lights. You may need to remove some trim panels to access it fully.


How do you remove a cigarette lighter socket from a Chevy S10 pickup?

To remove the cigarette lighter socket from a Chevy S10 pickup, first, disconnect the battery to ensure safety. Then, use a flathead screwdriver to carefully pry off the decorative cover around the lighter socket. Once exposed, gently twist and pull the socket from its housing, disconnecting any wiring attached. Finally, if needed, unscrew any retaining screws before fully removing the socket.


1986 Chevy S10 Tahoe pickup's battery goes dead after it sits for a week?

Weak battery that does not fully hold a charge? Hidden accesory left on i.e. glove box light, dome lights? Bad voltage regulator? excessive parasytic load?


What year did the first Chevy Silverado come out?

This is a Question???& Possible answer I know that the Chevy Silverado also came out in the 60's as my Dad had one bout it brand new In CA. Come on Guys come up with the right date on this It was a ton Pickup fully Loaded.


Where is the cabin air filter on a 2009 Chevy trailblazer?

The cabin air filter on a 2009 Chevy Trailblazer is located behind the glove compartment. To access it, you need to open the glove compartment, then remove the stops or clips to allow the compartment to drop down fully. The filter is housed in a compartment that can be easily pulled out for replacement.


How much does a fully loaded pickup truck weigh?

Not enough info to answer that question. The year, make and model info needed.


Rattling brakes on 1996 Chevy pickup?

If you front brakes rattle, it is usually caused by a a stuck puck or piston in your brake assembly. When this happens, the piston does not fully retract at times causing you brake pad or pads to wear excessibly and when the piston finally retracts fully and does not keep constant pressure on your pads you get a rattle. I had this problem on my F-150 and the brake guy solved this by installing steel pucks and lube.


How do you unlock a fully retracted drivers seat belt on a Chevy 2004 tracker?

Fully retracted or fully extended, the mechanism must be broken. Replace it with a new or good used one.


Where is cabin filter 2016 Chevy Colorado?

The cabin filter in a 2016 Chevy Colorado is located behind the glove compartment. To access it, you'll need to open the glove compartment, remove any contents, and then unclip the stops on either side to lower the compartment fully. The filter is housed in a rectangular cover that can be easily removed for replacement.


Why synonyms important in communication?

Synonyms are important in communication because if the person you are communicating with does not fully understand the meaning of a certain word, a synonym can be helpful in replacing that word with one they better understand. Example: If someone does not fully understand the word " benevolent", replacing it with the word "nice" could help he or she understand you.