Dot 3 or Dot 4
How do you replace the fuel pump Honda prelude 1992
in the manuel transmission through the check/fill plug
My 1992 Honda Accord Brake Lamp came on several times after I had the Master Cylinder replaced. Turns out the fluid had gotten low. Once I refilled the fluid level, the light stopped coming on.
I'm not sure what you mean here...are you wondering what tire size is on a 1992 Honda Prelude? Or, how do you get to the spare tire? Or, how do you remove a tire?
Where is the oil sending unit on a 1992 Honda Prelude? This car is with my son at college 200 miles away from our house.
In the same hole you check it in with a funnel you add it to the same hole you check it with .only in automatic trans
1342 on the 2.3L
NOT ONE
If you replace any brake component that breaks the brake fluid seal or you let it get very low of brake fluid, yes, you must bleed the brakes.
The easiest answer to this question is "www.installdr.com", there is a complete .pdf including diagrams on how to install the stereo for a 1992 prelude.
The OBD connector on a 1992 Honda Prelude is located under the dashboard, near the driver's side, typically just above the area where the brake pedal is located. You may need to remove a cover or panel to access it. It's usually a 16-pin connector, which is standard for OBD-I systems.
Yes, but it will involve modification to the body of the car. Check Prelude forums, the modification has been done and documented in detail.