answersLogoWhite

0

It could be a couple of things. On some vehicles, if one of the bulbs burn out in the taillight or turn signal circuit, both will stop working, but only on that side of the car. Some cars also have the brake lights wired through the hazard flasher, which if malfunctioning, can cause problems for both circuits, on both sides of the car.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

02 Chevy Malibu Rear brake lights and blinkers stopped working?

Check the fuse


Brake lights hazards and blinkers aren't working The bulbs flasher and fuses all seem to be good anyone know why the lights don't seem to be working on your 1996 jeep Cherokee sport 2wd?

might have a short in the wiring to the light socket!! same happen to me...


Your brake lights and blinkers stopped working and it is not the fuse What else could be the problem?

Bulbs? Sockets? Steering column switch?


My 87 Honda accord brake hazards and signal lights stopped working I changed signal and brake light fuses the brakes lights are working but not signal and hazards.?

Probably the flasher unit needs to be replaced. This is an electronic switch which usually mounts underneath the dashboard.


Why do your blinkers work but not your brake lights?

Blinkers can work without brake lights. Brake lights are activated by a switch that is switched by the brake petal and the turn signals are acivated by your turn signal switch on your steering column. The two are two separate circuits. I suggest you check out the switch on your brake pedal to see if it is working properly. It must have 12 volts applied to one side when it is not acitvated and 12 volts should be on both sides when it is activated. When the 12 volts is on both sides of the brake switch, it should apply 12 volts to your brake lights and then they should come on.


Whats the color wires for the blinker an brake lights?

whats the color circuit for the blinkers an break lights?


What fuse is to be replaced when the Brake Lights don't work on an 89 Ford Econoline Blinkers Hazards and Park Lights work?

The problem might not be a fuse. There is a switch which activates the brake lights when the brake pedal is depressed. This switch is usually mounted under the dash, near the top of the brake pedal lever. Insure that this switch is free to move physically, and test it to see if it is switching electrically.


Your brake lights and head lights do not work your blinkers and running lights do?

My rear window brake light works, but not my tail light brakes on my 1997 Monte Carlo. What is the problem?


Where is the ground wire for tail lights dashboard lights and blinkers?

I have a 1983 GMC Sierra it has no dash,tail lights an brake lights are very dim


Where is the sensor on the brake pedal I have no brake lights but the blinkers work and all fuses are good?

brake light switch is above the brake pedal under the dash


Does a 1977 Honda xl125 need a battery to run?

Well, that depends on whether you still have the lights and blinkers, ect. If there are not lights, blinkers, brake lights, or horn, then you do not need a battery to run this bike. If you do have these items, then you would need a battery


Why would your blinkers not work after the brake pads were changed?

it may have nothing to do with your brake pads on my car the blinkers stoped working they still came on but they stoped blinking and i just had to repace the bulbs