The John Deere D130 mower typically uses an oil filter with the part number AM125424. This filter is designed to fit the mower's engine, ensuring proper oil flow and filtration. Always check the owner's manual or consult with a dealer for the most accurate and up-to-date information regarding parts.
The correct one.
Oil Filter part # is AM107423
The standard replacement oild filter is the small Fram PH6607 or comparable. It is standard available filter that fits some small GM cars, some large motorcycles etc.
The PH4386 Fram filter also fits a 20 hp Briggs engine. I use it in my JD L120 lown mower instead of the $12 filter from the JD Dealer.
John deere part M806418, or I prefer the Mobil m1-110. The Mobile has the same interface at the screw on but is a little taller. Works fine and has a more filter element.
The Fram oil filter that fits a John Deere 650 is Fram PH5046. Fram is a company known for their quality oil filters. They come in a bright orange color.
To change the drive belt on a John Deere 260 lawn mower, first, ensure the mower is turned off and disconnected from the power source. Remove the mower deck by detaching any necessary bolts and pins, then locate and remove the old drive belt from the pulleys. Install the new belt by routing it according to the diagram usually found on the mower or in the owner's manual, ensuring it fits snugly on all pulleys. Finally, reattach the mower deck and double-check the belt alignment before testing the mower.
The John Deere 320 is compatible with several mower decks, including the 48-inch and 54-inch decks designed for the 300 series. Specifically, the 48-inch Mower Deck (Model 48) and the 54-inch Mower Deck (Model 54) are direct fits for the 320. Additionally, the 60-inch Mower Deck (Model 60) can also be used, but it may require additional components for proper installation. Always consult the owner's manual or a local dealer for specific compatibility and installation guidance.
Yes you can. Make sure it fits. I used import car filters. They work just fine and don't cost $10 or so each.
Do not know what you ask for, but try the link below to Deere:
To change the air filter on a 6.0 Craftsman lawn mower, first, ensure the engine is off and cool. Locate the air filter cover, typically on the side of the engine, and remove the screws or clips holding it in place. Take out the old air filter and replace it with a new one, ensuring it fits snugly. Finally, reattach the cover securely.