0
The sump plug washer for the Suzuki Bandit 650 K6 is typically an aluminum crush washer with a diameter of 14mm. It's important to replace this washer whenever you change the oil to ensure a proper seal and prevent leaks. Always verify with the motorcycle's service manual or parts catalog for the exact specifications.
What else can I help you with?
What size is the copper washer on a Nissan Note diesel sump plug?
what is the size of a nissan terrano sump plug washer
Is there a washer on the sump plug for rover 75 v6?
yeah
What is the sump plug washer caled on a Renault scenic the one with the rubber insert?
dowty washer
What is the size of the sump plug washer for a 2008 ZX6R?
The sump plug washer for a 2008 Kawasaki ZX6R typically has a size of 14mm inner diameter and 20mm outer diameter. It's usually made of aluminum or copper to ensure a proper seal and prevent leaks. Always verify with your specific model or consult the owner's manual for exact specifications.
What size sump plug do you need for a y reg clio?
What size sump plug do you need for a 2002 reg clio
Size of Renault megane senic 1.6 1999 sump plug?
The size of the Renault mMegane Ssenic 1.6 1999 sump plug is 9mm. You can find this plug at the bottom of the gearbox.
Where is oil drainage plug rover 200?
Hi the oil drain plug is under the engine on the sump it is very low to the ground so best to drive car up on to ramps to gain access to sump plug. Make sure you do not lose the copper washer on the sump plug hope this helps
Size of sump plug spanner for Renault scenic?
its 8mm square
What size is the sump plug on a fiat ducato mk3?
Should be a T50
How do you stop a leak from the oil release bolt on a dirt bike?
if its tight and still leaking you may need to re tap the hole into the block with a larger size thread and then insert a new larger size bolt.Investigations Person says;Providing that the bolt and sump threads are in good condition, check that a washer is not normally fitted, where I am most if not all sump plug bolts have copper washer fitted.
What size torx bit do you need for the oil sump plug on a holden vectra?
T45
What size torx bit do you need for the oil sump plug on a Holden astra?
You need aTorx 45 size
