its 8mm square
0.9mm
Its a 13mm spanner that you require.
dowty washer
autodata 2004 lists the gap for the 1.4 16v scenic as .9mm
My Scenic is a 2001 model with a 1998cc motor. The engine type is F4R which has 4 spark plugs. The spark plugs use a 5/8" socket plug. You will need about a 15cm extension on the socket as the plugs are situated deep inside the engine.
there isn't a drain plug, you will have to remove the bottom hose
The size of the Renault mMegane Ssenic 1.6 1999 sump plug is 9mm. You can find this plug at the bottom of the gearbox.
For a Peugeot 106, the spark plug spanner typically needed is a 16mm size. It's important to ensure that the spanner has a 12-point design for a better grip on the spark plug. Always check your vehicle's manual for any specific requirements or variations based on the engine model.
The spark plug spanner size for a 1972 MG B is typically 13/16 inch (21 mm). It's important to ensure that the spanner fits snugly to avoid damaging the spark plugs during removal or installation. Always check the specific spark plug type used in your vehicle, as variations can occur.
Hi Scenic owner,To access to the location, you have to remove engine cover by lifting the front part, ie nearer to you, then pull the cover towards you. This will prevent damaging the cover.Every spark plugs has its individual ignitor. It can be removed by unfastening bolt size 10mm socket.Once the ignitor is removed, the spark plug which is inside the plug well can be removed by using the right size spark plug socket wrench.Hope this help.
8mm square
the port is next to the fuse board which is right hand side of your steering wheel on a RHD car