0
What else can I help you with?
How many u-joints on a 2002 dodge ram 1500 quad cab?
The front axle shaft will be cv style, so zero there.The front drive shaft would have three.The rear drive shaft would have two if it is a one piece shaft, three if a two piece shaft.The front axle shaft will be cv style, so zero there.The front drive shaft would have three.The rear drive shaft would have two if it is a one piece shaft, three if a two piece shaft.
Can you swap drive shaft 06 silverado to a one piece?
You would need a drive shaft from a suburban
Could you Show the picture of the buick 1997 Drive Shaft Assembly?
There is no drive shaft because it is front wheel drive. The axles connect directly to tranny.
What is a carrier bearing?
The carrier bearing is located in the center of a two piece drive shaft. It holds up the center of the drive shaft. The drive shaft extends from the rear of the transmision to the rear drive axle (differental). The two piece drive shaft and the carrier are needed when there is a large angle between the transmission and the differental. The carrier bearing keeps the drive shaft up high under the vehicle.
What is carrier bearing?
The carrier bearing is located in the center of a two piece drive shaft. It holds up the center of the drive shaft. The drive shaft extends from the rear of the transmision to the rear drive axle (differental). The two piece drive shaft and the carrier are needed when there is a large angle between the transmission and the differental. The carrier bearing keeps the drive shaft up high under the vehicle.
How long is front drive shaft in 1963 Impala with 2 piece carrier bearing drive shaft OEM?
there is no front shaft in 63 impala Wrong answer, it's about two feet from the transmission to the carrier bearing
Is a carrier bearing pressed on a two piece drive shaft?
bottom center its the big round thing that hangs vertically and is the only thing around the actual drive shaft
How do you change drive shaft alfa 156?
To change the drive shaft on an Alfa Romeo 156, start by safely lifting the vehicle and securing it on jack stands. Remove the wheel and brake assembly to access the drive shaft. Disconnect the drive shaft from the transmission and the wheel hub, then carefully remove it from the vehicle. Install the new drive shaft by reversing the removal steps, ensuring all bolts are properly torqued and the components are reassembled correctly.
Is there any difference in the drive shafts used in the extended cab and regular cab S-10 pick up 1998 4-cylinder 5 speed?
The standard cab uses a one piece drive shaft. The extended cab uses a two piece drive shaft.
Is there any difference between drive shaft in extend cab 1998 S-10 and regular cab 2 part shaft 4cyl 5 speed manual?
A standard cab has a one piece drive shaft.
On a 2000 Chevy tracker with a two piece drive shaft can you replace just the carrier bearing without the entire drive shaft assembly?
I have a 98 4dr trackertwo wheel dr. autotrans with a two part shaft with center support assembly consisting of cv joint and rubber vibration dampner with spline. This shaft is approx $1000.00 from dealer. Apparently instead of rebuilding, a straight shaft is offerd for a fraction of the cost. however I was told this may stress the drie train (trans/differintial?).or cause vibration posibly from engin harmonics? Check with Rockauto.com for shaft and have picture emailed. personally. Id rather spend $250.00 for a straight one and take my chances. I also need to ask myself why do they (CARDONE) make the stright shaft if it dozent work. Who do I ask if it does work> The shaft this guys mentions is a front shaft, not the 2 piece shaft that is required. They do not make a straight shaft. Junkyard or new is the only way to get what you need. For a 4dr 4x2 automatic.
What is the piece of rubber called between the drive shaft and the transmission on a 1991 300D?
Guibo or Flex-disc
