0
On a 2000 Chevy tracker with a two piece drive shaft can you replace just the carrier bearing without the entire drive shaft assembly?
I have a 98 4dr trackertwo wheel dr. autotrans with a two part shaft with center support assembly consisting of cv joint and rubber vibration dampner with spline. This shaft is approx $1000.00 from dealer. Apparently instead of rebuilding, a straight shaft is offerd for a fraction of the cost. however I was told this may stress the drie train (trans/differintial?).or cause vibration posibly from engin harmonics? Check with Rockauto.com for shaft and have picture emailed. personally. Id rather spend $250.00 for a straight one and take my chances. I also need to ask myself why do they (CARDONE) make the stright shaft if it dozent work. Who do I ask if it does work> The shaft this guys mentions is a front shaft, not the 2 piece shaft that is required. They do not make a straight shaft. Junkyard or new is the only way to get what you need. For a 4dr 4x2 automatic.
What else can I help you with?
How do you change wiper transmission assembly Chevy Tracker 1998?
how to replace wiper transmission assembly on a 2001 tracker
What do I need to buy to replace the front wheel bearings on my 97 Geo Tracker front assembly or just the bearings?
you need to buy bearings and bearing races most times they will come as a set you will also need axle seals and you will need bearing grease
How do you replace a wheel bearing on a 2002 Tracker?
You will need to remove the tire and wheel from your 2002 Geo Tracker. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.
How do you replace a throwout bearing on a 97 Geo Tracker 2wd?
You need to remove the transmission from the vehicle. Most people would take this to a repair shop.
How do you replace license plate bulb for 2003 Chevy Tracker?
To replace the license plate bulb on a 2003 Chevy Tracker, first, open the rear hatch and locate the license plate light assembly. Use a flathead screwdriver to gently pry the light assembly out of its housing. Remove the old bulb by twisting it counterclockwise and replace it with a new bulb, ensuring it’s securely in place. Finally, snap the light assembly back into the housing and test the new bulb to ensure it’s working.
Is there a World War 2 British Aircraft Carrier The Tracker?
Yes, kind of. HMS Tracker (D24) was an escort aircraft carrier of the American "Bogue" class. She served in the Royal Navy from 1943 to 1945.
How do you replace bulb in shift console for 2004 tracker?
how to replace the light bulb on the gear shift on 2004 tracker
How do your replace the rear brake light on a 2002 Chevrolet tracker?
To replace the rear brake light on a 2002 Chevrolet Tracker, first, open the rear hatch and locate the brake light assembly. Remove the screws or clips securing the assembly and gently pull it out. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and then reassemble by reversing the steps. Make sure to test the new bulb before securing everything back in place.
How do i change the bearing on a 1996geo tracker front of a 4 wheel drive?
how do I get to the front bearing on a geo 4 wheel drive
2001 Tracker diagram front wheel bearing?
We can't do diagrams, sorry.
How do you replace the EGR on a Chevy Tracker?
repair timing chain on 2000 chevy tracker
How do you change the ignition lock cylinder in a 2001 Chevrolet Tracker?
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
