0
A Ford backhoe typically requires hydraulic fluid for its torque converter, often specified as ISO 46 or equivalent. It's important to consult the owner's manual or manufacturer specifications for the exact fluid type and viscosity recommended for your specific model. Using the correct oil ensures optimal performance and longevity of the hydraulic system.
What else can I help you with?
How many quarts of transmission fluid for a C6 Ford transmission including tourqe converter hold?
A C6 transmission including the torque converter will take 12.5 quarts.
Where is the torque converter located on a 92 ford areostar automatic van?
The torque converter in in the front of the transmission, the trans has to be removed to take it out, it comes out at the same time with the transmission. When you unbolt the trans, remove the starter to access the converter nuts holding it to the flexplate(flywheel). **If you didn't know this you are probably not qualified to take on this job*** Doug C
How much transmission fluid does a 1986 Ford Bronco II take What if it is totally dry?
10.5 Quarts if the torque converter is dry also.
How do you take torque converter off of engine so you can mount the motor on a stand?
The Torque Converter is part of the transmission, not part of the engine. The torque converter needs to come off with the transmission. You need to remove the starter to access the torque converter bolts/nuts and separate it from the flex plate. Besides loosing all of the fluid in the torque converter, you stand to damage converter seals and/or the pump if the converter isn't properly installed in the transmission.
Can you take 5.9 motor out of a 98 ram 1500 and put in your 99 durango that had a 5.2 motor in it?
It is possible, but the torque converter, computers are different.It is possible, but the torque converter, computers are different.
Which is the torque converter plug on a A4LD transmission?
It is on the torque converter itself. It is a 1/8 inch pipe plug that you have to take the cover of the bottom of the bell housing to get to and you need to rotate converter so it is at the lowest point of converter.
How hard is it to replace the torque converter seal on a 1986 ford ranger 4x4?
All you have to do is take the tranny out and unbolt it from the fly wheel, its really easy, I have done it a few times.
Do you have to take the torque converter off to replace the flexplate on a powerglide transmission?
yes
How do you replace the torque converter on a 2002 Chrysler sebring?
take your car to a shop if you must ask such a question. You obviously do not have the skill totackle such a complex task as remove the engine and then replace the Torque converter.
How do you replace a torque converter for 1994 mercury grand Marquis?
Remove the transmission and take it off.
How much of fluid goes in 5 speed transmission ford ranger?
If you are using Mercon LV I believe it should take 3 quarts, if you have drained the Torque Converter also use 5-6 quarts.
How do you take tork converteroff2000s-10 blazer?
Either the engine or the transmission has to come out to replace the torque converter.
