The best unit for filling your gas tank is gallons, as this is the standard measurement used in the United States for liquid fuels. In other countries, liters may be used, which is the standard metric unit for measuring fuel. Both units provide a clear indication of how much fuel is being added to the tank. Using these units ensures accurate billing and efficient fueling processes.
You would use the metric unit "liters" to measure the capacity of a hot water tank.
Liters or gallons, depending if your in Canada or US
The fuel sending unit is located in the fuel tank itself. To get to it, you would have to drop your fuel tank, and you would remove it from the top of the fuel tank.
Cubic meters are the best unit to measure the capacity of a shark tank because volume measurements like cubic meters can accurately represent the three-dimensional space inside the tank. Square meters measure area, not volume, and would not provide an accurate representation of the tank's capacity.
litres
In the US, a fish tank's capacity is measured in gallons.
I drop the tank.
The sugar would lay on the bottom of the tank so the only way to know would be to remove the tank and remove the sending unit to gain access to the inside of the tank.
The gas gauge sending unit would be located in the fuel tank.
To do an effective job cleaning a fuel tank, removing the tank from the vehicle and then removing the sending unit from the tank to gain access to the inside of the tank would be the way to go.
The fuel pump is in the tank. It is best to remove the tank to replace the fuel pump/sending unit, don't forget to hook up the hose inside the tank that goes to the sending unit!
It could quite possibly be the sending unit, that is located in the fuel tank. The electronic "board" gets crudded up and you must drop the fuel tank and pull out the sending unit which is part of the fuel pump. It's best to have as little fuel as possible in tank when doing this but It's not that difficult if you have a little mechanical ability. Two straps hold tank to frame. Drop tank, pull unit from top of tank, clean or replace.