answersLogoWhite

0

BAD RELAY answer bad switch bad relay and most likely, bad clutch

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Will oiling clutch on ac compressor help?

Oiling the a/c clutch will cause the clutch to slip and burn up........


What would cause both the AC and Heat to quit working?

A/C fan clutch is bad. A/C fan clutch is bad.


What would cause the ac not to turn on in a 2000 Chevy Malibu?

there are a few things that will cause this, relay or fuse to ac blown, if low on freon ac will not work. check and see if clutch on ac motor works. if not its the relay.


What would cause AC compressor to not run on 96 sunfire - no blown fuses but no power on green wire to the compressor clutch?

Maybe the compressor clutch is not being sent power from the switch in the cab. I'd yank the panel out and have a look at the switch. FriPilot


Your ac will not come on a 1987 Chevy Celebrity what can you check for?

Low or no freon will cause the AC not to work. Also if the clutch on the AC compressor has failed, or if the compressor itself failed.


Is it ok to run vehicle without air pressure in ac compressor?

On a vehicle with a compressor with a cycling clutch, yes.


What would be the cause if when the engine makes a light screeching noise when the AC is off but when turned on the noise goes away on my focus?

There may be some drag on the AC clutch when it is disengaged as the clutch 'free-wheels' during this time. When you engage the AC ,the clutch 'locks up' and the noise disappears. If the noise gets worse you may need to replace the clutch, if it stays the same and it not very loud, I would not replace it.


What would cause a roaring sound when the ac is on in a 1999 Ford Explorer?

Could be clutch cooling fan engaging


How do you replace the AC compressor clutch on 2006 Jeep Liberty?

how do you replace the AC compressor clutch on 2006 liberty


How AC compressor clutch bearing?

The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.


How do you replace the clutch and bearing on a ac compressor for a 2002 Chevrolet blazer?

This requires special tools to remove and install the ac clutch and bearing. The air gap on the ac clutch must be done during install.


How do you jump ac compressor clutch?

Unplug the low side pressure sensor and run a jumper wire between the two terminals.