answersLogoWhite

0

The wire used for car horns is typically around 18 to 16 gauge, which corresponds to approximately 1.0 to 1.5 mm in diameter. This gauge is suitable for carrying the necessary current to activate the horn without overheating. Always ensure that the wire insulation is rated for automotive use to withstand the vehicle's environment.

User Avatar

AnswerBot

5d ago

What else can I help you with?

Related Questions

Can you connect a 6mm earth wire to a 2.5 mm earth wire?

A 6 mm earth wire can be used to replace a 2.5 mm earth wire, but if there is an existing 6 mm earth wire it must be 6 mm all the way to the earth, and not replaced by a smaller wire between it and the earth connection.


Why is wire sized in sq mm?

It is metric that is used in the European standard of wire measurement.


What is larger 2.0 or 3.0 electrical wire?

In electrical wire sizing, a 3.0 mm² wire is larger than a 2.0 mm² wire. The numbers refer to the cross-sectional area of the wire, with a higher number indicating a thicker wire that can carry more current. Thus, 3.0 mm² wire has a greater capacity and is typically used for higher power applications compared to 2.0 mm² wire.


What is 14SWG copper wire in mm?

14SWG copper wire has a diameter of 1.628 mm.


Does a wire with a diameter of 0.01 mm have lower resistance than a wire with 0.1 mm?

No, the wire with a diameter of 0.01 mm will have higher resistance compared to a wire with a diameter of 0.1 mm. Resistance of a wire is inversely proportional to its cross-sectional area, so a thinner wire will have higher resistance.


How many amps will taken in sq mm copper wire?

10 amps


What size of wire should you used to 10 amp load?

2.5 squre mm


What size wire dose a ground fault breaker use?

2.5 sq mm or 4.Sq mm coil is used for breaker in industries


Where is horn switch in 98 zx2?

The center of the steering wheel comes off by removing two 10 MM bolts of each side on the back of the steering wheel, facing toward the column. The switch is integrated into the air bag assembly. The red wire goes to the switch and down the column. If, when you press the horn, you hear a click, the switch is okay. There may be another problem with the relay or horn. I found that the horn itself it above the bumper behind the headlight on the passenger side of the car. You might check it also.


How do you wire up a starter on a 1994 Chevy Cavalier?

This car uses the permenant magnet light weight front drive GM starter. It has a main battery cable and a swith wire conected to it. 15 mm and 8 mm usually depending on what rebuilder had it apart.


How big is the stink horn mushroom?

90 to 110 MM


What wire do you need to run 7KW?

8square mm wire by youthbala