answersLogoWhite

0

You got more balls than i do :) I am confused what do you mean by ignition switch? typically on a remote starter you tap into the wires and you can do that under the column cover or meet the harness where it goes to the underdash. I want a remote starter but with the electrical system in the vous its a P.I.T.A. you got the passkey you gotta have an extra one, the alarm bypass. and other stuff. here is a list i found that will tell you most of what you have to do RENDEZVOUS 2002 -2003 GM's PK3 TRANSPONDER ANTI-THEFT System, Requires 791 Module and Extra Ignition Key PART COLOR LOCATION DIAGRAM

  • 12 VOLT CONSTANT----- ORANGE (+)..... IGNITION SWITCH HARNESS
  • STARTER--------------------YELLOW (+)..... IGNITION SWITCH HARNESS
  • IGNITION ------------------PINK (+).......... IGNITION SWITCH HARNESS
  • IGNITION 2----------------GREEN (+) ...... IGNITION SWITCH HARNESS
  • BLOWER 1---------------- ORANGE (+)..... IGNITION SWITCH HARNESS
  • PARKING LIGHTS ( - )--- LIGHT BLUE(-).... @ HEADLIGHT SWITCH
  • POWER LOCK-------------RED/BLACK......... BCM, PINK Plug
  • POWER UNLOCK---------RED/BLACK .........BCM PINK PLUG
  • LOCK MOTOR WIRE -----GRAY (+) ........... @ BACK of FUSEBOX
  • DOOR TRIGGER ----------BLUE/WHITE (-) ....@ BCM, PINK Plug
  • TRUNK RELEASE--------- WHITE/BLACK (-).....,@ BCM, GRAY Plug
  • HORN---------------------- BLACK (-)............... @ STEERING COLUMN
  • TACH ---------------------- PURPLE/WHITE ..... @ IGNITION COIL
  • BRAKE---------------------- WHITE (+) ............ @ BRAKE PEDAL Switch
  • FACTORY ALARM DISARM--PURPLE (-) ......... @ BCM, PINK Plug
NOTE *1 this vehicle uses a 1-Wire Door Locking System, a (-)Negative thru a 470 Ohm will LOCK and a Straight (-)Negative on the same wire will UNLOCK. Some units will also require extra Relays Part #775, See DIAGRAM. NOTE *2 the BCM is located at the FRONT of the CENTER CONSOLE under the RADIO.
User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

What wires are used too hook up remote stater in 84 caprice?

Wire cluster under dash by driver's foot. Installation kit should include a wire chart indicating what color wires are to be used


How do you hook up the wires to a starter on a 1978 350 rocket?

The large one from the positive side of the battery attaches to the large post mounted on the starter solenoid and a smaller purple wire that attaches to the small post on the starter solenoid marked "S". The small post on the starter solenoid marked "R" is not used with that vehicle. Any accessory power wires would also attach to the large post on the starter solenoid.


What is a remote control used for?

A remote control is used to control an electronic device form a distance without wires. It uses infrared or radio frequencies to transmit the data to the device.


How do the wires hook up to a starter solenoid on a 1992 Mercury Topaz?

On a 1992 Mercury Topaz, the starter solenoid has several terminals for connecting wires. Typically, the battery positive cable connects to the large terminal on the solenoid, while the other large terminal connects to the starter motor. A smaller terminal is used for the ignition switch wire, which activates the solenoid when the key is turned to the start position. Ensure all connections are secure and free of corrosion for proper operation.


Starter makes grinding noise after engine is warm but if the remote start is used there is no noise is this due to a relay through the ignition switch?

The starter should only be making noise if you attempt to start the car and the starter is going bad. It is possible that the remote starter is bypassing the mechanical starter. Starters are very easy to replace. Be sure to disconnect the car battery before doing so.


What tool is used to energize the starter motor with the ignition system disabled?

A remote starter switch that most mechanics have in their tool box or a simple jumper wire will work.


Where is the starter switch on a 2001 Daewoo leganza?

the starter solenoid is incorporated with the starter. you'll find two wires going to the starter. one is the control wire which actuates the contactor (starter solenoid) for the high amp circuit that drives the starter motor. and then there is the switch in the steering column that is used with the key.


What 2 wires turn over the starter on a 93 Dodge spirit so a toggle switch can be used?

Yellow(starter relay) and Dark blue(ignition run/start).


What color wires do you use to hook up rear light?

Red is used for a swithced positive circuit. Yellow is used for a constant positive circuit. Black is used for ground.


What is a car remote starter used for?

A car remote starter is used to start your vehicle’s engine from a distance without needing to be inside the car. It’s handy for warming up the engine in cold weather or cooling down the interior on hot days before you get in. With the press of a button on the remote, the car starts up while staying locked, and it usually runs for a set amount of time before shutting off if you don’t enter the vehicle.


How to install 1992 240sx starter?

When my starter went out and i replaced it, I used the same bolts and just slid it into the place where the old starter went. ( I had a KA24DE DOHC) I put it back in connected all the wires and she fired right up for me =) Good luck


Why will Everything work with remote except remote starter lights flash but no start both remotes?

If the lights on the dash all light up but does not crank, this is probably the immobilizer system killing the starter. This is only with cars with a chip in the key and when they put the remote starter in they used a 556u peice and probably took one of your chip keys and installed it in the car. When they wrapped the windings around your key cylinder to "trick the car to thinking the key is being used" they may not have secured it properly. If this car doesn't have a chip key then I'd check to make sure the starter wire (Starter side) is hooked up. On directed electronics products its usually a thick purple wire