answersLogoWhite

0

What else can I help you with?

Related Questions

Will a 96 Chevy rearend fit a 2001 Chevy 1500?

NO.


Your 97 Chevy pickup steering wheel vibrates heavily when you turn the wheel during parking is this the PS bearings?

bearings inside your sterring colum need replacing


How do you increase tow capacity?

Get a heavier duty rearend. the tow capacity is based on the rearend. Chevy 10, 12, and 14 bolt rearend.


What would a grinding rubbing noise be in the front tires of a 1994 Chevy lumina APV?

It could be brakes, bearings or something else altogether.


What caused your 1998 Chevy Tahoe to loose oil pressure after replacing rod and main bearings?

Perhaps excess bearing clearance?


2003 trailblazer making whistling noise toward center of engine?

it could be the idler puller rubbing on the bearings. we had to replace it on our 2006 Chevy trailblazer ext.


What causes the humming sound in your Chevy 2005 Trailblazer when I accelerate?

There could be a few things that can cause this humming sound. It could be the wheel bearings rubbing, it could be the gears rubbing, it could even be coming from the engine pistons.?æ


What type of vehicle is a rearend with serial number 15555679 from?

It is out of a 1988 Chevy suburban It is out of a 1988 Chevy suburban


Why would the emergency brake light and abs light come every once in a while in 2001 Chevy Tahoe?

When my 2003 suburban did it. It turned out to be bearings. After replacing the bearings, no problems since. The bearing assembly has abs sensor attached.


Can i have main bearings for a 1995 Chevy s10?

You can use main bearings on a 1995 Chevy S10. The bearings can be purchased at most auto parts stores.


What kind of rearend do a 1991 Chevy Camaro have?

8.5 inch 10 bolt.


Where is the oil pump located on a 1996 Chevy Cavalier and how hard is it to replace?

Near the bottom of the oil pan. There isn't really much point in replacing the oil pump without checking out the bearings. Get a little plastiguage and check the bearing tolerances. You can't do any good replacing the oil pump if the bearings are worn.