answersLogoWhite

0

It might be the bearings are shot in your jack shaft.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What will cause a Sears craftsman riding mower with a 20 HP Briggs and Stratton motor not prime?

loose line,[sucking air] hole in primer button, no gas,


What will cause the fuse to burn when you turn the key on a craftsman riding mower?

Usually a dead short in the wiring some where : check for cracks in wires ,key gone to ground, exctra exc.....


I changed the right rear tire on my craftsman riding mover Now the mover will not go into gear the gearshift can be changed without applying the breaks what can cause this?

Most Craftsman riding mowers have a key-way that slides in the groove on the axle and in the groove of the rim. If you didn't re-install this 1/4" square piece of steel back into the rim before you put the clip on the axle these symptoms will occur.


What would cause a Rough ride on a f-150 truck?

shocks need replaced .Un balanced tires, and fat women riding in the back!


Will a troy bilt riding mower grass catcher fit a craftsman riding mower?

Without looking at the setup it's hard to tell. The mower chute and the bag inlet should be right on as a mismatch would cause clogs. It should be too tough to rig a hook and loop to hang the bag.


Can throwing up too much put you into a coma?

Throwing up can cause dehydration, which can cause a person to pass out and slip into a coma.


Can throwing up cause dry socket?

Yes


Well if tuna fishers keep on throwing nets in the water without looking out for dolphins or riding boats next to dolphins cause sometimes they ride ON the d What might happen to dolphins in the fu?

there will be none left or very few any way


What should I do if my bicycle has busted spokes?

If your bicycle has busted spokes, you should take it to a bike repair shop to have the spokes replaced. Riding a bike with busted spokes can be dangerous and may cause further damage to the wheel.


What cause your craftsman lawn tractor stop running at the brake is release?

Check your chair switch!


What would cause a craftsman lawn tractor to idle up and then down?

You need to adjust your carburetor.


What should I do if my bike's derailleur hanger is bent?

If your bike's derailleur hanger is bent, you should take it to a bike shop to have it straightened or replaced. Riding with a bent derailleur hanger can cause damage to your bike's gears and affect its performance.