You probably have a bad ground connection somewhere under the dashboard. There are two places that the ground attaches one on the left & one on the right. Both are about 6in to 1 ft from the edge of the edge of the doors. I just replaced a wiring harness in a truck & it was a pain in the #*&$. It's a chore, no doubt but if it's driving you nuts then I would try that first. Good luck, John jlindsey@puppynuts.com
To install a digital speedometer on a 379 Peterbilt, first disconnect the battery and remove the existing speedometer from the dashboard. Next, connect the digital speedometer's wiring harness to the truck's speed sensor and any necessary power and ground connections. Secure the new speedometer in place and reassemble the dashboard. Finally, reconnect the battery and test the speedometer to ensure it is functioning correctly.
It is doing a guage check. Most big trucks and diesels do it. Not seen it in a gasoline engine though.
To install a speedometer cable on a 1991 Mercury Topaz GS, first, disconnect the negative battery terminal to ensure safety. Then, remove the dashboard panel to access the speedometer. Disconnect the old cable from the speedometer and transmission, then install the new cable by connecting it to both ends securely. Finally, reassemble the dashboard and reconnect the battery, ensuring everything is functioning properly.
Are you talking about the digital speedometer or the whole dashboard? .
In a 2005 Scion xB, the speedometer is typically controlled by the instrument panel fuse, which is often labeled as "IG" or "Instrument." If the speedometer is not functioning, checking the 10A fuse in the fuse box under the dashboard can help determine if it needs replacement. Additionally, issues with the vehicle's speed sensor can also affect the speedometer's performance.
Remove the dashboard cover. Remove the retaining ring, from the speedometer. Remove the speedometer cable from the back of the speedometer. Reverse the process to install the new speedometer.
On the dashboard...
To remove the speedometer from a 1974 Super Beetle, first, disconnect the negative battery cable for safety. Then, remove the dashboard cover and the screws securing the speedometer itself. Carefully disconnect the speedometer cable from the back of the speedometer, and then pull the speedometer out of the dashboard. Be sure to handle it gently to avoid damaging any components.
Yes, the speedometer in a 2004 Kia Spectra EX is part of the vehicle's instrument cluster, which is powered by a fuse. If the speedometer is not functioning, checking the related fuse in the fuse box is a good first step to diagnose the issue. The fuse box is typically located under the dashboard or in the engine compartment, and the specific fuse for the speedometer can be identified in the owner's manual.
On the Dashboard Under Your Speedometer
To reset the speedometer on a Renault Megane 2, turn on the ignition without starting the engine. Press the trip reset button on the dashboard until the display resets to zero. If the speedometer is not functioning properly, it may require checking the vehicle's sensors or electronic systems. Always consult the owner's manual for specific instructions related to your model.
The fuse for the speedometer on a 2001 Pontiac Bonneville is typically located in the fuse box, which is found under the dashboard on the driver's side. You can refer to the owner's manual for a detailed diagram that indicates the specific fuse for the instrument cluster or speedometer. If the speedometer is not functioning, check this fuse first for any signs of damage or blowing.