answersLogoWhite

0

he vechiles computer system needs it to monitor spark and fuel delivery so if it goes bad you will think its out of time if the sencor is bad it might run poor then a no start at all will happen.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the crankshaft position sensor on a 2002 Dodge Dakota 3.9L v6?

The crankshaft position sensor goes through the bellhousing behind the passenger side cylinder head.The crankshaft position sensor goes through the bellhousing behind the passenger side cylinder head.


What happens when a crankshaft sensor goes out?

when it goes out it just goes out:D when it goes out it just goes out:D when it goes out it just goes out:D


What is the purpose of the crankshaft sensor on a 1998 Kia sport age?

The crank sensor (real name is crankshaft position sensor) senses when a notch on the crankshaft goes by and sends a pulse to the car's computer. This tells the computer where the crankshaft is in it's rotation so that the computer will fire the spark plug and injectors at the correct time.


What happens if the crankshaft position sensor goes out in a 2001 Oldsmobile intrigue?

The engine won't start.


Where is the crankshaft sensor located on a 1994 Jeep Grand Cherokee?

It goes into the top of bell housing.


What happens when the crankshaft sensor goes bad?

If the sensor is erratic, then the engine could shake or sometimes not run. If the sensor is completely bad, then the car wont start at all.


How often should crankshaft sensor be changed?

Only when it goes bad, in most cases it will not go bad.


What happens when crankshaft sensor on 2001 Dodge pickup goes bad?

AN engine that will not run correctly if at all.


What is notch in a top of transmission on a 99 dodge 1500 4 By 4?

That is where the crankshaft position sensor goes.


What happens when the crankshaft position sensor on a 93 Ford Taurus sho goes bad?

car will not start up


Does a 1994 Ford Areostar with a 3.0 liter engine have a crank sensor?

According to my manual that goes up to 1996, yes the 3.0 does have a crankshaft position sensor.


Where is a crankshaft position sensor located on a 1997 dodge stratus es V6 2.5L?

the crank sensor goes through the top rear of the bell housing.

Trending Questions
Why does your front wheel make a knocking sound as it goes round? How much fork oil in a zzr 600? What is the procedure to install a timing belt 2001 Daewoo Nubira 2.2L? Will 235 75 15 tires fit on the rear of a 95 Astro van? Why empty shells makes noise of wind? How do you replace the rear brake shoes on a Ford Fiesta? What vehicles does a fram ca5058 fit? Your 1990 jag was running fine and when you turned the car off and went back to start it it would turn over but not start then it drained your battery? Why are car speaker 4 ohms and home speakers 8 ohms I understand the technical difference but why is there a difference? How do you change speakers in 2002 Mitsubishi montero sport xls? What would cause a thumping noise near the front driver side tire in a 1993 Toyota pickup while going up to twenty miles per hour and even worse when you turn left? Power difference between 350 and 355 using same parts? Can charging a car battery set off a carbon monoxide detector? How do you replace the back indicator bulb on a vauxhall corsa 1.2? Where can you find a wiring diagram for a 1991 GMC Vandura 2500 with a Starcraft Conversion? Where is the power sounder on MK5 Astra SRI? What engine oil weight would be best for your 2001 dodge ram 1500 with over 100k miles? What compound do car batteries use? How can I find a fuel line diagram from fuel pump to carburetor plus one that shows all the vacuum lines? Explain how to use a range of fault diagnostic equipment to investigate the problem?