0
What else can I help you with?
Why would air compressor stop turning half way making clunking noise on 95 Thunder Bird?
Most likely you have a damaged - locking a/c compressor internally.............
Where is the pivot point for backing and turning?
The pivot point for backing and turning a vehicle is generally located at the center of the rear axle. This is the point around which the vehicle rotates when making sharp turns or maneuvering in reverse. Understanding this point can help drivers navigate tight spaces more effectively.
Why is my bike making a clunking noise when I pedal?
Your bike may be making a clunking noise when you pedal due to issues with the chain, pedals, bottom bracket, or other components that may be loose or worn out. It is recommended to have a professional bike mechanic inspect and repair the bike to prevent further damage.
Would backing powder the same as backing soda when making a pizza?
No they are not the same. Besides, when making pizza dough, you should use yeast to leaven the dough.
What causes a high pitch whine on the drivers side of my 2005 Chevy trail blazer?
Depends. Do you always hear it or only when speeding up and slowing down. I have the same thing on mine but nothing is wrong with it. It's the transmission that's making the sound. Nothing to worry about unless you start to get a clunking or grinding sound, then you have problems...
Why is your car making a loud bang when backing up?
it is the tranny mount
Why is my Geo Tracker making clunking noises when driving slow and grinding and popping sounds when turning?
theres is to many things that could becausing it, so its hard to tell. the best thing to do is jack both front teires off the ground and try to wiggle the tires back and forth, there should be no play (or movement).
Backing accidents represents what percentages of fleet accidents?
Backing accidents typically represent about 25% of all fleet accidents. They can be costly and dangerous, making it important for drivers to practice safe backing maneuvers.
You Think your BMX freewheel is making a clunking noise when you peddle. when you stop pedaling you cannot hear the clunking anymore you can only hear it when you apply pressure to the peddles.?
Chain alignment is off between the freewheel and front chainring. Also check chain tension when installing the back wheel.
What could be the problem if your 99 Expedition with automatic 4wd is making a clunking noise at lower speeds when braking?
Check you E-Stop Brake on the rear.
Why is your 2000 kia sephia making clunking sounds when you turn corners?
Clunking sounds when turning corners in your 2000 Kia Sephia could indicate worn or damaged suspension components, such as struts, control arms, or bushings. It might also point to issues with the CV joints or axle shafts, especially if the noise occurs during sharp turns. Additionally, check for loose or damaged exhaust parts that may be knocking against the chassis. It's advisable to have a mechanic inspect the vehicle to diagnose and address the issue properly.
What are the laws in Indiana about backing?
as far as know the laws are the same in any state. the person backing up is responsible for making sure the path is clear behind their vrhicle.
