answersLogoWhite

0

Most likely: Bad bendex spring or starter solenoid. May be replaceable independently, but frequently integral part of starter. But, before anything else just make sure all your connections, including those at the battery, are clean and tight.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Why does the starter on your 75 corvette smoke when you hook up the battery?

The starter is stuck or apparently engaged, replace the starter to eliminate your problem.


When you turn the key in your 87 corvette it just clicks and the battery is good but if you jam starter with screwdriver she starts rite up but only after you get her to click whats her problem?

== == Try tapping on the solenoid(smaller cylinder attached to starter) while someone tries to start it. If it starts then the solenoid is bad and the entire starter solenoid needs to be replaced.


Your 1976 Corvette wil not turn over sometimes its like there is no battery it seems like it does this after it gets warm not sure what to do please help you?

I have a 1979 corvette and had the same problem. what I did was change the starter and the battery. it starts better than my new car.


How do you change starter on 1975 Corvette?

Remove the positive cable from your 1975 Chevrolet Corvette battery. Remove the two cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.


How do you replace a starter on 95 Corvette?

Remove the positive cable from your 1995 Chevy Corvette battery. Remove the cables from the front of your old starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


How do you Replace starter in 1988 Corvette?

You should begin by removing the positive cable from your 1988 Chevy Corvette battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.


How do you hot wire a 1989 Ford F-150?

Why would you hotwire. Why not fix the problem?AnswerRun a wire from the negative battery terminal to the negative on the coil.Use a screwdriver on the starter selonoid to turn over the starter and start the engine.


How do you remove a starter on your 1986 Corvette?

To remove the starter from a 1986 Corvette, first disconnect the negative battery cable to ensure safety. Then, lift the vehicle and support it on jack stands. Remove the starter mounting bolts and disconnect the electrical connections, including the battery and solenoid wires. Finally, carefully pull the starter out from its position and set it aside.


What does it mean when your won't start or turn over?

I means you have a battery problem or a starter problem or dirty/loose battery cable connections. If the battery is operating the starter and the starter is turning the engine over but the engine won't start and run, you may have a spark problem or a fuel problem.


Why would 1993 Isuzu clicks but will not turn over?

Starter solenoid. Can be tested by bypassing with a screwdriver. Possible low battery, bad connection at battery and cables or bad starter.


Can you start a truck with starter problem or do you have to tow it?

That depends upon what the starter problem is. If the battery is exhausted, you can use another vehicle's battery, with jumper cables.


Does a 1981 Corvette have a fusible link?

Yes, three in fact. They are located at the battery terminal of the starter solenoid.