It's best to install new speakers and your own amplifier. The stock system in these cars might say JBL but it's junk and you will see this when you remove one of the speakers. If you want to use existing speakers and amp no need to bypass amp. All that is needed is 12 volt switched power source to the amp through the harness(blue wire). Just completed on my 91 mercury grand marquis.
It is located under the passenger side seat. Slide the seat forward and remove the plastic cover that has JBL stamped on it. The amp will then be revealed.
The Amp is located in the trunk below the rear dash
Under the passenger seat
yes they can hit very hard if you have a good amp setup.
take off the large panel which goes from the rear door to the bacck seat ,roof to floor.screws under the carpet edge.panel pops/prys out.radio may not work when amp dead. radio speaker wires goes to amp 1st.thrn speakers bypass and skip amp for cheap fix
no i have a 1993 the amp that's in there is just for the four speaker you can run a amp kit for you twelves but don't forget that wiring kit you will need to power the amp that is in there jbl
Which car speakers are better to my honda accord 07. I am using 5 channel amp and 10 inch sub. I care about clear crisp sound, dont care about loudness or bass I use Sub JBL GTO939 and JBL GTO609C or Infinity REF9603ix and Infinity REF6500cx Which car speakers are better to my honda accord 07 JBL GTO939 and JBL GTO609C or Infinity REF9603ix and Infinity REF6500cx
Your mom NERD get a girlfriend LOSER
To install a Pioneer stereo in your 2005 Highlander with the factory JBL system, you will need a compatible wiring harness to connect the new stereo to the vehicle's electrical system, an adapter for the JBL amplifier, and a dash kit to properly fit the new unit into the dashboard. Additionally, you may need tools like a screwdriver and wire strippers for the installation process. It's also important to ensure that the Pioneer stereo is compatible with your vehicle's existing features, such as steering wheel controls, if applicable.
JBL 8 inch. 3.7 ohm
yeah it dont matter the ohms as long as its 2-4 ohms and u should be safe cause the amp will auto ajust to 2 ohm or 4 ohm...............good luck but u wont have the power to push it .....try it and if it dosent have power to push it ad an mtx amp This is a special JBL speaker for the Ford/JBL system. You can have it repaired for around $40 at www.simplyspeakers.com. Call 1-800-511-3343. Servcie takes about 1 week and it will perform just like new!