Timing marks are always on the crankshaft, usually on the pulley closest to the block. This is because the timing must be based upon the position of the number one piston, which is connected to the crankshaft.
The ignition timing marks can be found on the main pulley. The timing marks will be scattered on the outside edge of the pulley.
The 1996 Chevy 1.3 liter engine timing marks can be found on the front main pulley and on the flywheel. The timing marks will be scattered around the outside of both locations.
No need for timing marks on the outside of the engine that has no adjustable ignition timing.(DIS)
Timing marks are generally found on the flywheel or crankshaft pulley. This indicator is used to set the timing of an engine's ignition system.
The D16 ignition timing needs to be set to the middle of the three marks. Typically, these marks are red and are located before the TDC mark on the crank.
You dont.
Were are the timing marks on a 1991 acura legend
It has no timing marks because the ignition timing is set by the computer and isn't adjustable.
In the Mazda RX-7, ignition timing marks are crucial for setting the engine's timing correctly. The timing marks are typically located on the crankshaft pulley and the timing cover, allowing for precise alignment with a timing light. For optimal performance, the ignition timing should be set according to the manufacturer's specifications, which can vary depending on the engine model and configuration. Always refer to the specific service manual for your RX-7 model for accurate timing adjustments.
there are two kinds of timing marks. one is for ignition timing and one for valve timing.
The timing marks on a 1997 Suzuki Esteem is on the crankshaft pulley. The crank mark needs to line up with the ignition timing mark.
Diagram of ignition timimg marks