You can order running headlamps from the big name brand sporting good suppliers. You should try Sports Authority or Dicks Sporting Goods might also have this product.
Some good places to buy running headlamps for night time running are ebay.ca and amazon.ca. A website specific for headlamps is ShopAdidas.ca/running.
undo the two 3/32 bolts running thru headlamp assemblies and remove headlamp assembly to access bulb
Special order the headlamp online or you might be able to find one on ebay or amazon.
i have looked at the schematics and i cannot find a headlamp relay, it is either straight wired or using either the ignition or accessory relay.
your headlamp switch on the dashboard has a small screw on it. its a 3 position switch. turn it to switch daytime running lights off.
Remove the wiring harness from the back of your 1999 Chevy Astro headlamp. Remove the headlamp retaining bolts. The headlamp will come out. Reverse the process to install the new headlamp.
1. Open the hood.2. Remove the thumb screw from the back of the headlamp.3. Release the headlamp retainer by lifting up.4. Pull the headlamp straight forward, to release the ball stud from the grommet.5. Remove the headlamp from the upper fascia support.6. Disconnect the electrical connector from the headlamp.7. Remove the bulb(s) from the headlamp by rotating counterclockwise.8. Release the headlamp trim tabs from the headlamp, if required.9. Remove the headlamp trim from the headlamp, pulling to release the adhesive tape.10. Clean adhesive from the headlamp trim and headlamp using 3M™ adhesive remover P/N 8984, or equivalent.To install:1. Install new adhesive tape 3M® P/N 6382 or equivalent to the headlamp trim, if necessary.2. Position the headlamp trim to the headlamp, if removed.3. Install the headlamp trim to the headlamp, pressing until end tabs are fully seated.4. Install the headlamp bulb(s) to the headlamp by rotating clockwise.5. Connect the electrical connector to the headlamp.6. Position the headlamp to the upper fascia support.7. Press the headlamp into the upper fascia support until the ball stud is fully seated.8. Install the thumb screw to the rear of the headlamp.9. Engage the headlamp vertical retainer, by sliding downward until fully seated.10. Check the headlamp aim, if a new headlamp was installed, or if service or repairs in the front end area were made.11. Close the hood.
It doesn't have a headlamp fuse. They have a circuit breaker built into the headlamp switch.
Open the hood to the engine compartment. Remove the headlamp wiring harness. Remove the headlamp assembly retaining bolts. The headlamp will come out.
To remove the headlamp from a Citroën Xsara Picasso, first, ensure the vehicle is turned off and the keys are removed. Open the bonnet and locate the headlamp assembly; you'll typically find screws or clips securing it in place. Remove these fasteners and carefully disconnect the electrical connector. Finally, pull the headlamp assembly forward to detach it from the vehicle.
Since power is the product of voltage and current, you will need to find out the power rating of the headlamp when on low beam. To find the current, divide the power of the lamp by the voltage (12 V).
Yes push the small button quickly 4 times located below the headlamp Knob