0
What else can I help you with?
Where is the knock sensor located in a 1991 Pontiac 6000 le?
In a 1991 Pontiac 6000 LE, the knock sensor is typically located on the engine block, often near the intake manifold or cylinder head. It may be positioned on the driver's side of the engine, mounted to the block. For precise identification, it's best to consult the vehicle’s service manual or a repair guide specific to that model.
What is the gap on the spark plugs for a 1991 Pontiac 6000 le?
.060"
Where is the knock sensor on a 1991 Pontiac 6000 LE 3.1?
on the engine block below the exhaust manifold. you can see it best by looking through the front passenger wheel well
Where is crankshaft position sensor located on 1991 Pontiac 6000 LE?
Rear of the engine block (firewall side), below the center spark plug, just above the oil pan.
Where is the oil sensor on a Pontiac 1989 6000 LE with a 2.8 V6?
It is next to the oil filter.
Why won't my 1985 Pontiac 6000 start?
have a pontiac 6000 2.5 motor and it wont stay running
Where is th low side ac port on a Pontiac 6000 3.1l?
The Pontiac 6000 low side air-conditioner import can be found on top of the air conditioning compressor. The low side air-conditioner port will be labeled as the low pressure port.
Where is the turn signal flasher in a 1991 Pontiac 6000?
In a 1991 Pontiac 6000, the turn signal flasher is typically located under the dashboard, near the steering column. It is often found plugged into the fuse box or mounted on the steering column itself. To access it, you may need to remove some panels or the lower dash cover. Always consult the vehicle's manual for specific details and diagrams.
1985 Pontiac 6000 fan will not turn on?
Could be a bad coolant temperature sensor, fan relay or thermostat. keep in mind the fan motor itself may be bad.
What is measurements for installing new outer tie-rods on Pontiac 6000 fwd?
The replacement of outer tie rod ends onto a Pontiac 6000 does not require "measurements." However, the vehicle will need to an alignment after install. An alignment usually takes initial measurements of the wheel geometries, and the technician uses these to adjust the wheels back into specification. For the 1991 Pontiac 6000, the final year of production, the AC Delco Professional outer tie rod is part number 45A0230.
Where is the ignition module on a 1985 Pontiac 6000?
On the distributor.
1990 Pontiac 6000 3.1 won't start. Repalced ignition module and tried a new pcm...no help. Good fuel pressure at the fuel rail 42 psi.?
First, double check your plug wire routing from when you changed the ICM. It could also be a bad crankshaft position sensor.
