Master cylinder, under hood, driver's side, firewall.
Same place you check it.
open the cap on the brake mastercylinder reservoir and fill it to the top with Dot 3 brake fluid.
tell u fill the reservoir ...you don't need to add brake fluid unless u have a leak...if your brake fluid is low but not full that means you could have worn pads and there is no need to add brake fluid....if u have bad pads u will hear a scraping noise...if the brake pedal is spongy like soft you could have air in the lines and needs to be bled...there could b more problems but that's the basics
the brake fluid level is low in your master cylinder, add some brake fluid and the light will stay off
Good question. At the brake fluid resovoir
ADD BRAKE FLUID
This can be two reasons for this....(1) is that your emergency brake is not fully OFF or (2), your brake fluid is past the LOW level in your brake fluid container in the engine....just add more brake fluid to top it up to FULL level and the brake light will go off.
You open the hood, find the brake fluid reservoir, take the cap off and add DOT 3 brake fluid up to the full level.
You can add brake fluid inside the brake fluid reservoir. The reservoir is located on the driver's side under the micro-filter panel.
if your brake fluid is low, you probably need to replace your brake pads. If your pads are good and you fluid is low, you have a leak somewhere. By replacing your pads, the brake fluid level will rise to the proper level. If you add fluid now, then replace your pads, brake fluid will leak out the top of your fluid reservoir and most likely eat the paint off what ever it spills on. Brake fluid and car paint DO NOT MIX.
Locate the brake fluid reservoir, and pour brake fluid in until it's at the appropriate level.
by the dipstick !! : )