Clutch shares fluid reservoir with brake system, open drivers door and pull off small plastic panel at side of dashboard.
To adjust the clutch on your Kia Pregio, you will need to locate the clutch cable under the hood. Loosen the locknut on the clutch cable, then turn the adjusting nut to either tighten or loosen the cable as needed. Once you have made the necessary adjustments, tighten the locknut back in place. It is important to ensure the clutch pedal has the correct amount of free play after making adjustments to prevent premature wear on the clutch components.
http://www.ebay.co.uk/itm/KIA-PREGIO-WORKSHOP-REPAIR-MANUAL-2004-/300919205330
the correct torque for cylinder head bolt of kia pregio 2.7 diesel is 130-135ft-lbs.
The correct tire pressure of kia pregio is 50 psi.If the ambient temperature is higher,say going above 35deg,then keep it 45psi
where to fill washer fluid back window 2012 kia sedona
Under the little front bonnet.
Ineed my code ratio for my kia pregio 3.0 2000
Open the driver door and its on the side of the dash, where the hinges are. Just give the plastic cover a good pull and it will come off.
Hydraulic clutches have an access plug located on the top of the bell housing. You'll need a long funnel or some tubing to fill
IN THE BRAKE MASTER CYLINDER RESERVOIR.
Check the level of the clutch fluid in the Kia Spectra's reservoir that's located in the rear left of the engine bay. The Kia Spectra actually used the brake master as its source of fluid for the clutch. Add fluid to the recommended level if it's low, then pump the clutch pedal to restore the pressure in the line. If the fluid level doesn't remain the same, you might have a leak in the system. Replace or repair any leaking parts.2 Adjust the height of the clutch pedal by turning the knob at the top of the pedal of the Kia Spectra. This changes the point at which the pedal engages. Test the pedal and tighten the adjuster knob when you are done.3 Bleed the clutch to remove any air bubbles from the system. Open the bleeder valve that's located on the slave cylinder (near clutch housing) and insert a tube. Put the other end of the tube into a clear container with clutch fluid. Pump the clutch pedal until you don't see any air bubbles in the container. Replace the fluid in the brake master cylinder.4 Inspect the components of the Kia Spectra's clutch: the flywheel, pressure plate and disc. Replace the clutch components if they're worn.Read more: How to Adjust the Clutch in a Kia Spectra | eHow.com http://www.ehow.com/how_4484785_adjust-clutch-kia-spectra.html#ixzz16y2sthH4
On a 1999 Kia Sephia, the clutch fluid reservoir is typically located near the back of the engine bay, close to the driver's side. It is usually a small, translucent container marked with a "clutch" label. To check or add fluid, you should ensure the engine is off and locate the reservoir; it is often connected to the clutch master cylinder. Use the appropriate brake fluid type as specified in the owner's manual.