It is located in the block, usually along the back if the motor is transverse, and along the side in any other case.
it's on the right front of the engine, not far from the crankshaft sensor
The knock 1 sensor on a Vortec 4.8 is located on the top of the engine. You will have to remove the intake to gain access to replace it.
The knock sensor just advances and retards the engine timing only. If there is a noise in the engine then you have engine are valve train problems. The knock sensor will not make the engine knock.
i know what the part looks like but i cannot locate it on the engine.
The knock sensor is located on the front of the engine, just above the oil filter mount. It should have a single Dark Blue wire connected to it.
i need to locate knock sensor on a 2000 infiniti g20
To install the knock sensor on a 1996 BMW Z3 1.9 engine, first, ensure the engine is cool and disconnect the battery. Locate the knock sensor, which is typically positioned on the engine block near the cylinder head. Remove the old sensor by unscrewing it and disconnecting the electrical connector. Install the new sensor by connecting it and securing it in place, then reconnect the battery and start the engine to check for proper function.
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
Yes it can hurt your engine to drive with a bad knock sensor. The knock sensor should be replaced as soon as possible.
The 2006 Dodge charger knock sensor is located on the back of the engine. The knock sensor will be near the bottom of the engine cover.
There is no "knock sensor" on a 4.0L engine
This is controlled by a knock sensor.